Engine Speed/Timing Sensor - Clean/Inspect
Show/hide table
图 1 | g00798212 |
正时圆盘前盖中的发动机转速/正时传感器 |
- 从护盖上拆下传感器。 检查磁铁端的状况。 检查有无磨损和污染迹象。
- 清理磁铁表面的金属屑和其它碎屑。
- 安装传感器并根据发动机的技术规格调整传感器。
Caterpillar Information System:
3054 and 3056 Engines 520 Generator Set Control Panel Factory Default Values of Configuration Parameters
3126B and 3126E On-highway Engines 0096-03 Fuel Level voltage high
3054 and 3056 Engines 520 Generator Set Control Panel Wiring Diagrams
385B Excavator Disconnecting Hydraulic Hoses and Lines
3116 Truck Engine Charging System - Test
3512B and 3512C Engines For Caterpillar Built Machines Heating System
3116 Truck Engine Piston Ring Groove - Inspect
SCT673 Truck Mounted PumperPOD Hydraulic Oil Sample - Obtain - Gear Case
3054 and 3056 Marine Generator Set Engines Exhaust Manifold
3054 and 3056 Engines 520 Generator Set Control Panel Connector Contact Description
3116 Truck Engine Engine Oil Pressure - Test
3116 Truck Engine Engine Valve Lash - Inspect/Adjust
Power Module Switchgear (Low Voltage and Medium Voltage) Receiving Inspection
Power Module Switchgear (Low Voltage and Medium Voltage) Storage
Power Module Switchgear (Low Voltage and Medium Voltage) Handling
3126B and 3126E On-highway Engines 0096-04 Fuel Level voltage low
Power Module Switchgear (Low Voltage and Medium Voltage) Installation
Power Module Switchgear (Low Voltage and Medium Voltage) Initial Startup Safety Check
3126B and 3126E On-highway Engines 0128-03 Secondary Fuel Level voltage high
3126B and 3126E On-highway Engines 0128-04 Secondary Fuel Level voltage low
CIPI UNDERCARRIAGE Arrangements: 9Q-5262, 191-4041, and 204-9207 Track Carrier Roller - Remove
2001/11/01 Changes were made in the Communication Link for the Marine Monitoring System II (MMS II) and the Generator Monitoring System (GMS) {7490}
CIPI UNDERCARRIAGE Arrangements: 9Q-5262, 191-4041, and 204-9207 Track Carrier Roller - Install
Power Module Switchgear (Low Voltage and Medium Voltage) Initial Startup Procedure