Installation
Sufficient space must be provided when conduits enter the switchgear or raceways for cable enter the switchgear. This space must be provided in order to permit the proper bending of cables. Sufficient clearances must be maintained between energized components. Review the publication "National Electric Code". Refer to Section 384-10 of the code.
Install a ground cable from the ground electrode for the site to the ground bus bar for the switchgear. Review the "National Electric Code". See Sections 250-91(a), 250-92(a), 250-93 and or 250-94 for further details and requirements concerning the sizing of the ground wire.
The publication "NFPA No. 70HB96" is available from the National Fire Protection Association.
Caterpillar Information System:
3126B and 3126E On-highway Engines 0096-04 Fuel Level voltage low
Power Module Switchgear (Low Voltage and Medium Voltage) Handling
Power Module Switchgear (Low Voltage and Medium Voltage) Storage
Power Module Switchgear (Low Voltage and Medium Voltage) Receiving Inspection
G3408 and G3412 Engines Engine Speed/Timing Sensor - Clean/Inspect
3054 and 3056 Engines 520 Generator Set Control Panel Factory Default Values of Configuration Parameters
3126B and 3126E On-highway Engines 0096-03 Fuel Level voltage high
3054 and 3056 Engines 520 Generator Set Control Panel Wiring Diagrams
385B Excavator Disconnecting Hydraulic Hoses and Lines
3116 Truck Engine Charging System - Test
3512B and 3512C Engines For Caterpillar Built Machines Heating System
3116 Truck Engine Piston Ring Groove - Inspect
Power Module Switchgear (Low Voltage and Medium Voltage) Initial Startup Safety Check
3126B and 3126E On-highway Engines 0128-03 Secondary Fuel Level voltage high
3126B and 3126E On-highway Engines 0128-04 Secondary Fuel Level voltage low
CIPI UNDERCARRIAGE Arrangements: 9Q-5262, 191-4041, and 204-9207 Track Carrier Roller - Remove
2001/11/01 Changes were made in the Communication Link for the Marine Monitoring System II (MMS II) and the Generator Monitoring System (GMS) {7490}
CIPI UNDERCARRIAGE Arrangements: 9Q-5262, 191-4041, and 204-9207 Track Carrier Roller - Install
Power Module Switchgear (Low Voltage and Medium Voltage) Initial Startup Procedure
3126 Truck Engine Flywheel Housing
Power Module Switchgear (Low Voltage and Medium Voltage) General Maintenance Information
CIPI UNDERCARRIAGE Arrangements: 9Q-5262, 191-4041, and 204-9207 Track Carrier Roller - Disassemble
C7 and C9 On-Highway Engines 0186-04 PTO Engine Shutdown Switch voltage low
CIPI UNDERCARRIAGE Arrangements: 9Q-5262, 191-4041, and 204-9207 Track Carrier Roller - Assemble