Electric Starting Motor - Remove and Install
Removal Procedure
- Place an index mark on all of the electrical wires that are connected to the electric starting motor. Disconnect the electrical wires from the electric starting motor.
- Fasten a suitable lifting device to the electric starting motor.
Show/hide table
Illustration 1 | g00519372 |
Typical example |
- Remove three bolts (1) .
- Remove the electric starting motor and the gasket from the flywheel housing. The weight of the electric starting motor is 29 kg (65 lb).
Installation Procedure
- Inspect the condition of the gasket. Replace the gasket, if necessary.
- Install the gasket on the electric starting motor.
- Fasten a suitable lifting device to the electric starting motor.
Show/hide table
Illustration 2 | g00519372 |
Typical example |
- Place the electric starting motor in the flywheel housing. Install three bolts (1) .
- Connect all of the electrical wires to the electric starting motor by using the index marks.
Caterpillar Information System:
3408E and 3412E Industrial Engines Valve Rocker Arms and Lifters
C-12 Marine Engines Cylinder Head - Install
3176C and 3196 Marine Engines Rocker Shaft and Pushrod - Install
3176C and 3196 Marine Engines Speed/Timing Sensor - Remove and Install
3176C and 3196 Marine Engines Crankshaft Rear Seal - Install
2000/02/01 Correction to Specifications Module, SENR6436-00, "3114 & 3116 Diesel Truck Engines" {1201}
3176C and 3196 Marine Engines Crankshaft Rear Seal - Remove
3176C and 3196 Marine Engines Crankshaft Front Seal - Install
3176C and 3196 Marine Engines Crankshaft Front Seal - Remove
3176C and 3196 Marine Engines Cylinder Liner - Install
3500B and 3500B High Displacement Generator Set Engines Electronic Control Terms
3176C and 3196 Marine Engines Cylinder Liner - Remove
3176C and 3196 Marine Engines Engine Oil Filter Base - Remove
2000/05/01 New Format of PC Software for Customer Communication Module {1926}
3176C and 3196 Marine Engines Engine Oil Filter Base - Install
3176C and 3196 Marine Engines Engine Oil Filter Base - Disassemble
3176C and 3196 Marine Engines Engine Oil Filter Base - Assemble
3176C and 3196 Marine Engines Engine Oil Cooler - Remove
3126B and 3126E On-highway Engines Customer Passwords
325D and 329D Excavators Hydraulic System Cylinders (Boom, Stick and Bucket)
3176C and 3196 Marine Engines Engine Oil Cooler - Install
3176C and 3196 Marine Engines Engine Oil Pump - Remove
3176C and 3196 Marine Engines Engine Oil Pump - Install
3176C and 3196 Marine Engines Engine Oil Pump - Disassemble