Speed/Timing Sensor - Remove and Install
Removal Procedure
- Remove bolt (1) and the washer from clip (3) .
Show/hide table
Illustration 1 | g00518483 |
- Disconnect speed/timing sensor connector (2) .
- Remove speed/timing sensor (3) .
- Remove O-ring seal (5) from speed/timing sensor (4) .
Show/hide table
Illustration 2 | g00518484 |
- Extend slip head (6) for the installation procedure.
Installation Procedure
- Inspect the condition of the O-ring seal. Replace the seal, if necessary.
- Install O-ring (5) and extend slip head (6) .
Show/hide table
NOTICE |
---|
The No. 1 piston must be at either top center of the compression stroke or top center of the exhaust stroke. After sensor installation the electronic timing must be recalibrated. |
Note: Refer to the Troubleshooting Manual, "Engine Speed/Timing Sensor Calibration".
Show/hide table
Illustration 3 | g00518484 |
- Install speed/timing sensor (4). Tighten the sensor to a torque of 40 ± 5 N·m (30 ± 4 lb ft).
Show/hide table
Illustration 4 | g00518485 |
Note: Ensure that the top of a gear tooth is visible through the speed/timing sensor opening in the front housing prior to installation. See Illustration 4.
Show/hide table
Illustration 5 | g00518483 |
- Connect speed/timing sensor connector (2) .
- Install clip (3) with bolt (1) and the washer.
- Recalibrate the timing.
Caterpillar Information System:
3176C and 3196 Marine Engines Crankshaft Rear Seal - Install
2000/02/01 Correction to Specifications Module, SENR6436-00, "3114 & 3116 Diesel Truck Engines" {1201}
3176C and 3196 Marine Engines Crankshaft Rear Seal - Remove
3176C and 3196 Marine Engines Crankshaft Front Seal - Install
3176C and 3196 Marine Engines Crankshaft Front Seal - Remove
3176C and 3196 Marine Engines Cylinder Liner - Install
3500B and 3500B High Displacement Generator Set Engines Electronic Control Terms
3176C and 3196 Marine Engines Cylinder Liner - Remove
Product Link 151/201 System Overview
3408E and 3412E Engines for Caterpillar Built Machines Engine Design
3176C and 3196 Marine Engines Crankshaft Main Bearings - Install
3176C and 3196 Marine Engines Crankshaft Main Bearings - Remove
3176C and 3196 Marine Engines Rocker Shaft and Pushrod - Install
C-12 Marine Engines Cylinder Head - Install
3408E and 3412E Industrial Engines Valve Rocker Arms and Lifters
3176C and 3196 Marine Engines Electric Starting Motor - Remove and Install
3176C and 3196 Marine Engines Engine Oil Filter Base - Remove
2000/05/01 New Format of PC Software for Customer Communication Module {1926}
3176C and 3196 Marine Engines Engine Oil Filter Base - Install
3176C and 3196 Marine Engines Engine Oil Filter Base - Disassemble
3176C and 3196 Marine Engines Engine Oil Filter Base - Assemble
3176C and 3196 Marine Engines Engine Oil Cooler - Remove
3126B and 3126E On-highway Engines Customer Passwords
325D and 329D Excavators Hydraulic System Cylinders (Boom, Stick and Bucket)