Crankshaft Main Bearings - Remove
Removal Procedure
Show/hide table
Required Tools     | |||
Tool     | Part Number     | Part Description     | Qty     |
A     | 2P-5518     | Bearing Tool     | 1     |
Start By:
- Remove the oil pan.
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Remove bolts (1) that hold crankshaft main bearing cap (2). Remove crankshaft main bearing cap (2) .
Show/hide table
Illustration 1 | g00516918 |
- Remove the lower half of the crankshaft main bearing from crankshaft main bearing cap (2) .
- Use the following steps in order to remove the upper half of crankshaft main bearings (3) :
- Turn the crankshaft until Tool (A) can be installed in the crankshaft journal. Install Tool (A) .
- Turn the crankshaft in order to remove the upper half of the crankshaft main bearing. In order to get the tab out first, the crankshaft must be turned in the correct direction.
- Check the condition of the crankshaft main bearings. Refer to the Guideline For Reusable Parts, SEBF8009, "Main and Connecting Rod Bearings" or refer to the Guideline For Reusable Parts, SEBF0531, "Main and Connecting Rod Bearings".
Show/hide table
Illustration 2 | g00516920 |
Typical example |
Show/hide table
NOTICE |
---|
If the crankshaft is turned in the wrong direction, the tab of the crankshaft main bearing will be pushed between the crankshaft and the cylinder block. this can cause damage to either or both the crankshaft and the cylinder block. |
Show/hide table
Illustration 3 | g00516919 |
- Remove thrust plate (4) .
Caterpillar Information System:
2000/02/01 Electronic Marine Engine Installation Guides are now Available {1000, 7451}
2000/02/01 114-2410 Pyrometer Battery Shelf Life Extended {7466}
3176C and 3196 Marine Engines Crankshaft - Install
3176C and 3196 Marine Engines Crankshaft - Remove
3176C and 3196 Marine Engines Crankshaft Gear - Remove and Install
3512B Petroleum Engines Aftercooler Coolant Temperature
3512B Petroleum Engines ECM Voltage
3512B Petroleum Engines Engine Oil Filter Differential Pressure
3512B Petroleum Engines Fuel Filter Differential Pressure
3512B Petroleum Engines Exhaust Temperature
3512B Petroleum Engines Low Coolant Temperature
3512B Petroleum Engines Crankcase Pressure
3176C and 3196 Marine Engines Crankshaft Main Bearings - Install
3408E and 3412E Engines for Caterpillar Built Machines Engine Design
Product Link 151/201 System Overview
3176C and 3196 Marine Engines Cylinder Liner - Remove
3500B and 3500B High Displacement Generator Set Engines Electronic Control Terms
3176C and 3196 Marine Engines Cylinder Liner - Install
3176C and 3196 Marine Engines Crankshaft Front Seal - Remove
3176C and 3196 Marine Engines Crankshaft Front Seal - Install
3176C and 3196 Marine Engines Crankshaft Rear Seal - Remove
2000/02/01 Correction to Specifications Module, SENR6436-00, "3114 & 3116 Diesel Truck Engines" {1201}
3176C and 3196 Marine Engines Crankshaft Rear Seal - Install
3176C and 3196 Marine Engines Speed/Timing Sensor - Remove and Install