Crankshaft - Remove
Removal Procedure
Start By:
- Remove the engine oil pump.
- Remove the front housing.
- Remove the flywheel housing.
- Remove the cylinder head.
- Remove the pistons and connecting rods.
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Remove bolts (1) .
Show/hide table
Illustration 1 | g00517115 |
- Remove crankshaft main bearing caps (2) .
- Remove crankshaft thrust bearings (3) .
Note: Crankshaft main bearing caps (2) are marked with the numbers 1 through 7. Crankshaft main bearing caps (2) that are not marked should be marked with the corresponding cylinder number on the side that is toward the right side of the engine.
- Install a suitable bolt into each end of the crankshaft. Fasten suitable lifting device (4) to the bolts in the crankshaft. Remove the crankshaft. The weight of the crankshaft is approximately 129 kg (285 lb).
Show/hide table
Illustration 2 | g00517116 |
- Remove the upper halves of the crankshaft main bearings.
Caterpillar Information System:
3176C and 3196 Marine Engines Crankshaft Gear - Remove and Install
3512B Petroleum Engines Aftercooler Coolant Temperature
3512B Petroleum Engines ECM Voltage
3512B Petroleum Engines Engine Oil Filter Differential Pressure
3512B Petroleum Engines Fuel Filter Differential Pressure
3512B Petroleum Engines Exhaust Temperature
3512B Petroleum Engines Low Coolant Temperature
3512B Petroleum Engines Crankcase Pressure
3512B Petroleum Engines Altitude Derate Feature
3176C and 3196 Marine Engines Coolant Temperature Sensor - Remove and Install
3176C and 3196 Marine Engines Lifter Group - Remove and Install
3176C and 3196 Marine Engines Inlet and Exhaust Valve Guides - Remove and Install
3176C and 3196 Marine Engines Crankshaft - Install
2000/02/01 114-2410 Pyrometer Battery Shelf Life Extended {7466}
2000/02/01 Electronic Marine Engine Installation Guides are now Available {1000, 7451}
3176C and 3196 Marine Engines Crankshaft Main Bearings - Remove
3176C and 3196 Marine Engines Crankshaft Main Bearings - Install
3408E and 3412E Engines for Caterpillar Built Machines Engine Design
Product Link 151/201 System Overview
3176C and 3196 Marine Engines Cylinder Liner - Remove
3500B and 3500B High Displacement Generator Set Engines Electronic Control Terms
3176C and 3196 Marine Engines Cylinder Liner - Install
3176C and 3196 Marine Engines Crankshaft Front Seal - Remove
3176C and 3196 Marine Engines Crankshaft Front Seal - Install