Crankshaft - Install
Installation Procedure
Show/hide table
Required Tools     | |||
Tool     | Part Number     | Part Description     | Qty     |
A     | 8T-5096     | Dial Indicator Group     | 1     |
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Place the upper halves of the crankshaft main bearings in the cylinder block. Place the lower halves of the crankshaft main bearings in crankshaft main bearing caps.
Show/hide table
NOTICE |
---|
Ensure that the crankshaft main bearing tabs engage with the grooves in the block and the crankshaft main bearing cap. |
- Fasten suitable lifting device (4) to the crankshaft and place the crankshaft in the cylinder block.
Show/hide table
Illustration 1 | g00517116 |
- Install crankshaft thrust bearings (3) .
Show/hide table
Illustration 2 | g00517179 |
- Install crankshaft main bearing caps (2) with the part numbers toward the right hand side of the cylinder block. Ensure that crankshaft main bearing caps (2) have numbers 1 through 7. The numbers should start at the front of the engine. Place clean engine oil or Molylube on the bolt threads and the washers. Install bolts (1). Tighten the bolts to a torque of 95 ± 5 N·m (70 ± 4 lb ft).
Show/hide table
Illustration 3 | g00517115 |
- Place an index mark on each bolt head. Turn the bolts for an additional 90 ± 5 degrees (1/4 turn).
- Check the end play of the crankshaft with Tool (A). The end play must be 0.10 mm (.004 inch) to 0.50 mm (.020 inch).
Show/hide table
Illustration 4 | g00517182 |
End By:
- Install the pistons and connecting rods.
- Install the flywheel housing.
- Install the front housing.
- Install the engine oil pump.
- Install the cylinder head.
Caterpillar Information System:
3176C and 3196 Marine Engines Crankshaft - Remove
3176C and 3196 Marine Engines Crankshaft Gear - Remove and Install
3512B Petroleum Engines Aftercooler Coolant Temperature
3512B Petroleum Engines ECM Voltage
3512B Petroleum Engines Engine Oil Filter Differential Pressure
3512B Petroleum Engines Fuel Filter Differential Pressure
3512B Petroleum Engines Exhaust Temperature
3512B Petroleum Engines Low Coolant Temperature
3512B Petroleum Engines Crankcase Pressure
3512B Petroleum Engines Altitude Derate Feature
3176C and 3196 Marine Engines Coolant Temperature Sensor - Remove and Install
3176C and 3196 Marine Engines Lifter Group - Remove and Install
2000/02/01 114-2410 Pyrometer Battery Shelf Life Extended {7466}
2000/02/01 Electronic Marine Engine Installation Guides are now Available {1000, 7451}
3176C and 3196 Marine Engines Crankshaft Main Bearings - Remove
3176C and 3196 Marine Engines Crankshaft Main Bearings - Install
3408E and 3412E Engines for Caterpillar Built Machines Engine Design
Product Link 151/201 System Overview
3176C and 3196 Marine Engines Cylinder Liner - Remove
3500B and 3500B High Displacement Generator Set Engines Electronic Control Terms
3176C and 3196 Marine Engines Cylinder Liner - Install
3176C and 3196 Marine Engines Crankshaft Front Seal - Remove
3176C and 3196 Marine Engines Crankshaft Front Seal - Install
3176C and 3196 Marine Engines Crankshaft Rear Seal - Remove