Rotor Drive Belt - Inspect
Show/hide table
插圖 1 | g06134159 |
(1) 可調整的止動螺栓
(2) 皮帶 |
- 打開轉子驅動帶的左側轉子皮帶檢修門,然後裝上桿子將門鎖定在打開位置。
Show/hide table
插圖 2 g06319087 可調整的止動螺栓
(A)17 ± 3 mm (0.7 ± 0.1 inch) - 拆下皮帶護板。 如有必要,取下可調整的止動螺栓 (1)。
附註如果需要取下可調整的止動螺栓 (1),請讓可調整的止動螺栓回到
17 ± 3 mm (0.7 ± 0.1 inch) 的距離。 - 檢查轉子皮帶 (2) 是否有斷裂。 檢查皮帶是否有燒灼點。 檢查轉子皮帶是否與繫帶分離和過度磨損。 檢查繫帶是否有磨損、孔洞或起泡。
- 在皮帶護板底部尋找是否有皮帶的殘留物。 如果皮帶出現打滑或過度磨損的跡象,請更換皮帶。
Caterpillar Information System:
An Alignment Procedure for the Fan Support Group as Part of the Radiator Guard Group Is Now Used on the 836K Landfill Compactor {0635, 1353, 1356, 1360, 1386, 7251} An Alignment Procedure for the Fan Support Group as Part of the Radiator Guard Group Is Now Used on the 836K Landfill Compactor {0635, 1353, 1356, 1360, 1386, 7251}
MD6200 Rotary Drill Cab Air Filter (Fresh Air) - Clean/Replace
725C2 and 730C2 Articulated Truck Machine System Rear Suspension Frame - Remove and Install
An Improved Paint Masking Process Is Now Used on the Front Axle Steering Cylinders for Certain Backhoe Loaders {4303, 4313} An Improved Paint Masking Process Is Now Used on the Front Axle Steering Cylinders for Certain Backhoe Loaders {4303, 4313}
C175–16 Locomotive Engine Air in Fuel - Test
2570D and 2670D Wheel Feller Buncher Engine Supplement Engine - Remove and Install
725C2 and 730C2 Articulated Truck Machine System Center Suspension Frame - Remove and Install
994K Wheel Loader Machine Systems Lift Cylinder - Remove and Install
R1700 Load Haul Dump Power Train, Steering, Braking, Hydraulic, and Machine Systems Ride Control Accumulator - Test and Charge
797F and 797F XQ Off-Highway Trucks Magnetic Plug (Pump Drive, Hydraulic) - Check
M0077220 (NEHS1231) 115V & 230V Battery Chargers {1401, 751B} M0077220 (NEHS1231) 115V & 230V Battery Chargers {1401, 751B}
Medium L and M Series Wheel Loaders Cat Production Measurement Application on Machines Equipped with Product Link: PLE631 or PLE641 Editing Truck and Material Lists
PM310, PM312, and PM313 Cold Planer Rotor Drive Clutch Bearings - Lubricate
PM310, PM312, and PM313 Cold Planer Steering Cylinder Ends - Lubricate
New Hose Clamps are Now Used in the Coolant Lines Group of Certain 700 Series Articulated Trucks {1087, 1380} New Hose Clamps are Now Used in the Coolant Lines Group of Certain 700 Series Articulated Trucks {1087, 1380}
PM310, PM312, and PM313 Cold Planer Water Spray System - Inspect
563D and 573D Wheel Feller Buncher Machine Systems Control Manifold (Hydraulic Fan) - Remove and Install
PM310, PM312, and PM313 Cold Planer Water Spray System Fluid Level - Check
MH3037 Material Handler Engine Supplement Turbocharger - Remove and Install - Second Stage Turbocharger
CP54B, CS54B and CS64B Soil Compactors Machine Systems Operator Controls (Vibratory System)
797F and 797F XQ Off-Highway Trucks Visual Service Procedure (VSP) Maintenance Intervals Electric Drive Pump (Powered Stairway) Oil Level - Check - If Equipped
797F and 797F XQ Off-Highway Trucks Visual Service Procedure (VSP) Maintenance Intervals Manual Lowering (Powered Stairway) - Test - If Equipped
797F and 797F XQ Off-Highway Trucks Visual Service Procedure (VSP) Maintenance Intervals Platform (Powered Stairway) - Lubricate - If Equipped
730C2 and 725C2 Articulated Truck Power Train Front Axle - Remove and Install