Diesel Exhaust Fluid Filter - Replace
Show/hide table
插圖 1 | g06133494 |
柴油排液 (DEF,Diesel Exhaust Fluid) 濾清器位於泵電子油箱單元 (PETU,Pump Electronics Tank Unit) 的底部。 PETU 位於機器左側。
Show/hide table
插圖 2 | g03332612 |
典型範例 |
Show/hide table
不當處理化學製品可能會導致人員受傷。 請務必使用所有必要的防護設備以進行作業。 使用任何化學製品前,務必詳閱並瞭解標籤與物料安全資料表上說明的所有指示與危險資訊。 請遵守化學品製造商建議的所有安全預防措施,以處理、存放及棄置化學製品。 |
Show/hide table
注意事項 |
---|
執行任何維修或修復工作前,請確保引擎已停止。 |
Show/hide table
注意事項 |
---|
在檢驗、保養、測試、調整及修理產品時,請小心確保油液有容器盛裝。 在打開任何艙室或拆卸任何含有用液的組件前,應準備好盛裝用液的適當容器。 請參閱專門出版物, NENG2500, "Cat 代理商工具目錄"或參閱專門出版物, PECJ0003, "Cat 商店供應和工具目錄",了解適合收集和盛裝 Cat 產品用液的工具和供應品。 按照當地的條例和法規棄置廢棄的油液。 |
- 使用
27 mm (1.06 inch) 扳手拆下柴油排液 (DEF) 濾清器蓋 (3)。 - 拆下 DEF 濾清器 (1) 上的橡膠錐嵌環 (2)。
Show/hide table
插圖 3 g03332637 典型範例 - 將 DEF 濾清器拆卸工具 (4) 插入 DEF 濾清器 (1),並拆下 DEF 濾清器 (1)。
附註當您處理 DEF 濾清器拆卸工具 (4) 時,請戴上手套。 拆下時請避免扭曲 DEF 濾清器 (1)。 因為扭曲可能會造成撕裂。
- 清潔濾清器外殼周圍的區域。
- 使用柴油排液或蒸餾水,潤滑新 DEF 濾清器 (1) 的密封件。
- 裝上新的 DEF 濾清器 (1) 以及橡膠錐嵌環。 使用
27 mm (1.06 inch) 扳手將濾清器鎖緊至20 ± 5 N·m (14.8 ± 3.7 lb ft) 的扭矩。附註安裝時請避免扭曲 DEF 濾清器 (1)。 因為扭曲可能會造成撕裂。
Caterpillar Information System:
988K, 990K, 992K and 994K Wheel Loaders Cat® Production Measurement Application / VIMSTM Network Manager Simple Calibration
PM310, PM312, and PM313 Cold Planer Diesel Exhaust Fluid - Fill
PM310, PM312, and PM313 Cold Planer Cooling System Coolant Sample (Level 2) - Obtain
PM310, PM312, and PM313 Cold Planer Coolant Sample (Level 1) - Obtain
PM310, PM312, and PM313 Cold Planer Cooling System Coolant Level - Check
PM310, PM312, and PM313 Cold Planer Cooling System Coolant Extender (ELC) - Add
797F and 797F XQ Off-Highway Trucks Visual Service Procedure (VSP) Maintenance Intervals Powered Stairway - Check
797F and 797F XQ Off-Highway Trucks Visual Service Procedure (VSP) Maintenance Intervals Hoist Screens - Clean
440 and 450 Backhoe Loader Hydraulic Coupling Quick Disconnect - Clean/Inspect
422F2, 426F2, 428F2, 432F2, 434F2 and 444F2 Backhoe Loaders Locks - Lubricate
730C2 and 725C2 Articulated Truck Power Train Center Axle - Remove and Install
422F2, 426F2, 428F2, 432F2, 434F2 and 444F2 Backhoe Loaders Cooling System Coolant (ELC) - Change
PM310, PM312, and PM313 Cold Planer Engine Air Filter Primary Element - Clean/Replace
PM310, PM312, and PM313 Cold Planer Engine Mounts - Inspect
PM310, PM312, and PM313 Cold Planer Engine Oil Level - Check
PM310, PM312, and PM313 Cold Planer Engine Oil Sample - Obtain
PM310, PM312, and PM313 Cold Planer Engine Oil and Filter - Change
2570D and 2670D Wheel Feller Buncher Engine Supplement Engine Oil Cooler - Remove and Install
PM310, PM312, and PM313 Cold Planer Fuel Tank Water and Sediment - Drain
PM310, PM312, and PM313 Cold Planer Hydraulic System Oil - Change
PM310, PM312, and PM313 Cold Planer Hydraulic System Oil Filter - Replace
PM310, PM312, and PM313 Cold Planer Hydraulic System Oil Level - Check
PM310, PM312, and PM313 Cold Planer Hydraulic System Oil Sample - Obtain
PM310, PM312, and PM313 Cold Planer Legs (Struts) - Lubricate