Diesel Exhaust Fluid - Fill
Show/hide table
| 注意事項 |
|---|
|
在檢驗、保養、測試、調整及修理機器時，請小心確保油液有容器盛裝。 在打開任何艙室或拆卸任何含有用液的組件前，應準備好盛裝用液的適當容器。 按照當地的條例和法規棄置廢棄的油液。 |
偏好設定: 請參閱操作及保養手冊, "容量 (加注)"，以瞭解機器柴油排液油箱的容量。
Show/hide table
| |
| 插圖 1 | g03379943 |
|
DEF 油箱加注口蓋 | |
Show/hide table
| |
| 插圖 2 | g06133481 |
- 清潔加注口蓋 (1) 及周圍區域。
- 取下加注口蓋。
- 將柴油排液 (DEF) 加注到柴油排液油箱。
附註請勿從受到污染的容器或漏斗加注 DEF 液箱。
附註請勿加注到滿溢油箱。 DEF 可能會凍結，因此需要膨脹的空間。
附註若在引擎起動開關位於 ON (開啟) 位置時加注柴油排液油箱，當柴油排液油箱加滿後，機器喇叭會鳴響兩次。
- 裝上加注口蓋。
如需柴油排放處理液 (DEF) 指南的詳細資訊，請參閱操作及維護手冊, "潤滑黏度"。
Caterpillar Information System:
PM310, PM312, and PM313 Cold Planer Cooling System Coolant Sample (Level 2) - Obtain
PM310, PM312, and PM313 Cold Planer Coolant Sample (Level 1) - Obtain
PM310, PM312, and PM313 Cold Planer Cooling System Coolant Level - Check
PM310, PM312, and PM313 Cold Planer Cooling System Coolant Extender (ELC) - Add
797F and 797F XQ Off-Highway Trucks Visual Service Procedure (VSP) Maintenance Intervals Powered Stairway - Check
797F and 797F XQ Off-Highway Trucks Visual Service Procedure (VSP) Maintenance Intervals Hoist Screens - Clean
440 and 450 Backhoe Loader Hydraulic Coupling Quick Disconnect - Clean/Inspect
422F2, 426F2, 428F2, 432F2, 434F2 and 444F2 Backhoe Loaders Locks - Lubricate
730C2 and 725C2 Articulated Truck Power Train Center Axle - Remove and Install
422F2, 426F2, 428F2, 432F2, 434F2 and 444F2 Backhoe Loaders Cooling System Coolant (ELC) - Change
Procedure to Install an Improved Clean Fuel Module Relay on Certain 793F, 795F, and 797F Large Off-Highway Trucks {1408, 1417, 1422, 4493} Procedure to Install an Improved Clean Fuel Module Relay on Certain 793F, 795F, and 797F Large Off-Highway Trucks {1408, 1417, 1422, 4493}
C175-16 and C175-20 Engines for Off-Highway Truck/Tractors Exhaust Has Excessive White Smoke
988K, 990K, 992K and 994K Wheel Loaders Cat® Production Measurement Application / VIMSTM Network Manager Simple Calibration
PM310, PM312, and PM313 Cold Planer Diesel Exhaust Fluid Filter - Replace
PM310, PM312, and PM313 Cold Planer Engine Air Filter Primary Element - Clean/Replace
PM310, PM312, and PM313 Cold Planer Engine Mounts - Inspect
PM310, PM312, and PM313 Cold Planer Engine Oil Level - Check
PM310, PM312, and PM313 Cold Planer Engine Oil Sample - Obtain
PM310, PM312, and PM313 Cold Planer Engine Oil and Filter - Change
2570D and 2670D Wheel Feller Buncher Engine Supplement Engine Oil Cooler - Remove and Install
PM310, PM312, and PM313 Cold Planer Fuel Tank Water and Sediment - Drain
PM310, PM312, and PM313 Cold Planer Hydraulic System Oil - Change
PM310, PM312, and PM313 Cold Planer Hydraulic System Oil Filter - Replace
PM310, PM312, and PM313 Cold Planer Hydraulic System Oil Level - Check