Usage:
NOTE: Cleanliness is an important factor. Before assembly, all parts should be thoroughly cleaned in cleaning fluid. Allow the parts to air dry. Wiping cloths or rags should not be used to dry parts. Lint may be deposited on the parts which may cause later trouble. Inspect all parts. If any parts are worn or damaged, use new parts for replacement.
NOTE: Lubricate all parts with clean hydraulic oil during assembly.
1. Install the O-ring seal on plug (2). Install plug (2) in the valve body.
2. Install O-ring seals (3) in cover (1). Install cover (1) on the valve body.
3. Install the orifice in passage (4) if it was removed. Use a 3G-7628 Spacer to hold the orifice in the valve body.
4. Install shims (6) in spool (5). Install spool (5) and spring (7) in the valve body.
5. Install O-ring seal (8) on plug (9). Install plug (9) in the valve body.
6. Install valves (10) and springs (11) in their original locations in the valve body.
7. Install sleeves (12), spring (13) and sleeves (14) on valve spool (15).
8. Install valve spool assembly (16) in the valve body.
9. Install O-ring seals (17) on cover (18). Install cover (18) on the valve body.
10. Install the cover and flange (19) on the valve body.
End By:
a. Install the secondary steering diverter valve. Refer to Disassembly and Assembly, "Secondary Steering Diverter Valve - Install" for the machine that is being serviced