Usage:
426C (1CR1-183, 1MR1-276, 6XN1-727, 1YR1-345),
436C (1FR1-221, 1PR1-310, 2AR1-226, 8TN1-303) BACKHOE LOADERS
Problem:
There is concern about interference between the 8T-4201 Bolt on the lower E-stick and the 9R-8466 Tube on the rod end. The interference may result in damage to the tube.
On the early C-Series Backhoe Loaders, two 8T-4121 Washers were used under the head of the 8T-4201 Bolt to improve the retention of the upper pad of the E-Stick. On some units, this allows the head of the bolt to contact the 9R-8466 tube Assembly at full extension of the stick.
Solution:
If interference occurs, remove one of the two 8T-4121 Washers to the 8T-4201 Bolt.
If interference still occurs, verify that the welded-in elbow on the rod end of the 6E-0404 Cylinder Group is in the correct position. When the cylinder is installed this elbow must point directly at the inside corner of the E-Stick extension
These changes have been made with the following effectivity:
- 4ZN239 1YR346
- 6XN728 2AR227
- 8TN304 1MR277
- 1CR184 1PR311
- 1FR222 1WR851
- 6XN728 2AR227
COPYRIGHT 1997 CATERPILLAR ALL RIGHTS RESERVED