Engine Accelerator Cable Rubbing Against Reservoir
Usage:
TELEHANDLERTH63 (3NN1-841, 5WM1-1672) TH82 (3JN1-593, 3KN1-422) TH83 (3RN1-1167) TELEHANDLER
Problem:
There have been reports of the engine accelerator cable rubbing against the bottom of the 036-1864 Reservoir used to recover coolant. If left undetected, this rubbing may wear through the reservoir causing the coolant to run out.
Solution:
The rubbing can be prevented by elevating the 083-1864 Reservoir. The steps are as follows.
- 1. Lift up 036-1864 Reservoir (1).
- 2. Bend the lowest part of the 036-1863 Bracket (2) up about 13 mm (.5 in). See Illustration 1.
- 3. Lower 036-1864 Reservoir (1).
- 4. Check to make sure that the accelerator cable clears the reservoir.
If the accelerator cable does not clear the 036-1864 Reservoir, use a 7K-1181 Cable Strap to secure the accelerator cable. Secure the accelerator cable so that the accelerator cable is not kinked or that its travel is not limited.
COPYRIGHT 1997 CATERPILLAR ALL RIGHTS RESERVED
Caterpillar Information System:
Information Survey For Boom Rolling Hose Failures Information Survey For Boom Rolling Hose Failures
Refrigerant Compressors May Fail Refrigerant Compressors May Fail
Idler Stub Shaft Mounting Bolts; Idler Gear Sleeve Bearings Idler Stub Shaft Mounting Bolts; Idler Gear Sleeve Bearings
Interference Between The Lower E-Stick Pad Retaining Bolt And The Rod End Tube Assembly Interference Between The Lower E-Stick Pad Retaining Bolt And The Rod End Tube Assembly
Hydraulic Oil May Transfer To The Transmission Hydraulic Oil May Transfer To The Transmission
Procedure To Replace Boom Hour Glass Plate Due To Cracks Procedure To Replace Boom Hour Glass Plate Due To Cracks
C-Series Backhoe Loader Ride Troubleshooting Guide C-Series Backhoe Loader Ride Troubleshooting Guide
PS-150B Cooling Package Modifications PS-150B Cooling Package Modifications
Service Meter Is Clocking Hours When The Machine Is Not Operating Service Meter Is Clocking Hours When The Machine Is Not Operating
European Union Directive 95/27/EC, External Dynamic Sound European Union Directive 95/27/EC, External Dynamic Sound
Increased Power Train Oil FLow Can Decrease Final Drive Oil Temperature Increased Power Train Oil FLow Can Decrease Final Drive Oil Temperature
Improved Lubricaiton Flow Through The Inner Rear Wheel Bearing Improved Lubricaiton Flow Through The Inner Rear Wheel Bearing
8T-0855 Brake Pressure Gauge May Fail 8T-0855 Brake Pressure Gauge May Fail
8T-6762 Pipe Plugs Not Correctly Tightened In 9Y-8914 Air Lines Group 8T-6762 Pipe Plugs Not Correctly Tightened In 9Y-8914 Air Lines Group
Possible Fuel Leak From The Weep Hole In Stanadyne Model DB4 Fuel Injection Pumps On 3054 and 3056 Engines Possible Fuel Leak From The Weep Hole In Stanadyne Model DB4 Fuel Injection Pumps On 3054 and 3056 Engines
Spindle Retaining Bolts On The Suspension Support Axle May Loosen Spindle Retaining Bolts On The Suspension Support Axle May Loosen
Unapproved Refrigerant Use In Caterpillar HVAC Systems May Adversely Effect Air Conditioner Performance Unapproved Refrigerant Use In Caterpillar HVAC Systems May Adversely Effect Air Conditioner Performance
Low Engine Idle Speed Causes Excessive Vibration Low Engine Idle Speed Causes Excessive Vibration
3300 Engine Timing Measurement For Reduced Emissions And Improved Engine Performance/Life 3300 Engine Timing Measurement For Reduced Emissions And Improved Engine Performance/Life
Some Remanufactured Electric Starter Groups May Have An Incorrect Nose Housing Some Remanufactured Electric Starter Groups May Have An Incorrect Nose Housing
Power Train Oil Flow May Be Lost On Slopes Power Train Oil Flow May Be Lost On Slopes
Rework To Prevent Scoring Of Rods In Hydraulic Cylinder Groups For Rear Struts Rework To Prevent Scoring Of Rods In Hydraulic Cylinder Groups For Rear Struts
Certain 824G Wheel Tractors, 825G Soil Compactors, 826G Landfill Compactors, And 980G Wheel Loaders Experience Brake Application Noise And Pedal Kickback Certain 824G Wheel Tractors, 825G Soil Compactors, 826G Landfill Compactors, And 980G Wheel Loaders Experience Brake Application Noise And Pedal Kickback
114-5930 Solenoid Assembly May Leak 114-5930 Solenoid Assembly May Leak