1999/06/01 Caterpillar


Correction To Certain Off-Highway Truck Service Manual Modules{0374}

Usage:


776D (5ER),
771D (6JR),
775D (6KR) Quarry Trucks;
769D (5TR),
773D (7ER),
777D (3PR) Off-Highway Trucks

SUPPLEMENT: JULY 12, 1999

Service Magazine, SEPD0474, Article 10, Page 10, June 1, 1999; "Correction To Certain Off-Highway Truck Service Manual Modules".

Disregard this article and see Service Magazine SEPD0480, Article 22, Page 32 with the same title.

--------------- END SUPPLEMENT ---------------

Reference: Service Magazine SEPD0217; Page 4; "Maintenance Interval For Steering Components, Hoist Cylinder Bearings and Rear Axle Housing "A" Frame Bearings Has Changed".

Description of Change: The Maintenance Intervals in the manuals listed below are incorrect. The maintenance intervals should be "Every 50 Service Hours or Weekly".

Service Manual Module, SEBU6902-01; April, 1997, 769D Off-Highway Truck & 771D Quarry Truck; Operation and Maintenance Manual; Page 96, "Maintenance Intervals" for the following; Page 128, "Steering Cylinder Bearings"; Page 129, "Steering Tie Rod and Pin Bearings"; Page 130, "Hoist Cylinder Bearings"; and Page 131, "Rear Axle Housing "A" Frame Bearing". This module is found in Service Manual SENR8605, 769D Truck & 771D Quarry Truck.

Service Manual Module, SEBU6968-01; July, 1997, 773D Off-Highway Truck & 775D Quarry Truck; Operation and Maintenance Manual; Page 109, "Maintenance Intervals" for the following; Page 142, "Steering Cylinder Bearings" and "Steering Tie Rod and Pin Bearings"; Page 144, "Hoist Cylinder Bearings" and "Rear Axle Housing "A" Frame Bearing". This module is found in Service Manual SENR1400, 773D Truck & 775D Quarry Truck.

Service Manual Module, SEBU6757; May, 1996, 776D Wheel Tractor & 777D Off-Highway Truck; Operation and Maintenance Manual; Page 90, "Maintenance Intervals" for the following; Page 125, "Steering Cylinder Bearings" and "Steering Tie Rod and Pin Bearings"; Page 1230, "Hoist Cylinder Bearings" and "Rear Axle Housing "A" Frame Bearing". This module is found in Service Manual SENR6905, 776D Wheel Tractor & 777D Truck.

Effective with: 776D (5ER1-Up), 771D (6JR1-Up), 775D (6KR1-Up), 769D (5TR1-Up), 773D (7ER1-Up), 777D (3PR1-Up),

Caterpillar Information System:

1999/06/01 New Exhaust Manifold Groups (Bellows Type) Used{1059}
1999/06/01 Improved Counterweight Group Eases Retaining Rod Installation{7056}
1999/06/01 Addition Of Drainage Hole Eliminates Water Accumulation In Winch Frame{7053}
1999/06/01 New Boom Upper Sheave Block Improves Cable Spooling{5415}
1999/06/01 Pump And Suction Elbow Changes Improve Assembly Alignment{5084}
1999/06/01 Backhoe Loader Window Latch Rod Now Serviceable{7308}
1999/06/01 Special Instruction, REHS0377, Available For Installing Spacers On New Backhoe Loader Booms For The Fitup Of Hydraulic Lines{5057}
1999/05/24 Air Conditioner Service Tips{7320,7337}
1999/05/24 New DT Connector Plugs With Improved Seal Retention{1408,7553}
1999/05/24 New Main Bearing Material{1203}
1999/05/24 New 155-5175 AC Current Probe For Generator Sets Now Available{1400,4450,0734,7002}
1999/05/24 New 153-9630 Sensor Test Group Adapter Kit For DataView Now Available{1000,3000,4000,5000,6000,0788,0785}
1999/06/01 Correction To Special Instruction REHS0263; 785C Off-Highway Truck Assembly Procedure{0374,7960}
1999/06/01 785 Steering Pump (4T-0382) Installation/Startup Procedure{4306}
1999/06/01 Special Instruction Available For Adjusting The Hydraulic Electronic Controls{0374,5702}
1999/06/01 New Vibratory Pump And Higher Efficiency Motor Improves Compactor Performance{5070,5058,5651,5652}
1999/06/01 Rotor Drive Chain Part Number Has Changed{3159}
1999/06/01 Installation Of Auxiliary Fuse Wiring For Additional Power Source{1417}
1999/06/01 Bolt Callout In Propel Planetary Is Incorrect{4050,4011}
1999/06/01 Use 154-8100 Fuel System Arrangement And 154-8101 Fuel System Group To Measure Engine Fuel Flow{1250,0782}
1999/06/07 Improved Lift Cylinder Rod Now Used{5102,7120}
1999/06/07 New Automated Cylinder Cutout Test Available With Electronic Technician (ET) Version 2.4 Software Release{0781,1920}
1999/06/07 Common Charcoal Gray Paint Used{7581}
1999/06/07 New Cover Plate Improves Visibility{7262}
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.