1996/09/23 Caterpillar

New Clamp Assembly Used In Engine Oil Lines Groups {1307}

Usage:

G3606 (3XF),
G3608 (4WF),
G3612 (1YG),
G3616 (4CG) Engines

Reference: Engine News, March 1996, Page 13, "Be Sure To Remove Former Clips And Brackets If New Clamp Assembly And Retainer Ring Are Used In Engine Oil Lines Groups"

Description of Change: A new clamp assembly and associated hardware is used in the engine oil lines groups on these engines. The new clamp assembly will eliminate interference between the clamp assembly and the aftercooler water line. The new clamp assembly is easier to install than the former clamp assembly.

Adaptable To: The chart and illustration identify the new clamp assembly and associated hardware in the 105-3182 and 106-5652 Engine Oil Lines Groups.

(FRONT VIEW OF ENGINE) Location of the new 137-0257 Clamp Assembly (1) and associated hardware. Water Pump Location (A). Oil Pump Location (B).

Caterpillar Information System:

1996/09/23 Caterpillar High Efficiency Fuel Filters Help Provide Maximum Fuel Pump And Fuel Injector Life {1261}

1996/09/23 New Rotocoil Assembly Used In Valve Rocker Arm Groups {1109}

1996/09/23 New Wastegate Shaft And Bushing Provides Better Wear Resistance {1057}

1996/09/23 New Soot-Filter Available For Use With Air Cleaner Group {1055,1050}

1996/09/23 Improved Air Cleaner Element Assembly Used {1054}

1996/09/23 Turbocharger Water Wash Procedure {1052}

1996/09/23 Caterpillar Now Has Parts Support For Previously Non-Supported Custom Parts {7567}

1996/09/23 Introduction Of New Spark Ignited Single-Cylinder Gasket Kits {7555}

1996/09/23 New Circuit Board Assembly And Modules Improve Serviceability And Reliability {1418,1550}

1996/09/23 New Bracket Available To Support Gas Engine Ignition Group Wiring Harness Assembly {1408,1550}

1996/09/23 Addition Of Sleeve And Removal Of Setscrew Prevents Binding Of Control Shaft {1266,7558}

1996/09/23 New Valve Cover Seals Are Available For Mechanical Unit Injector (MUI) and Electronic Unit Injector (EUI) Engines {1107}

1996/09/23 Procedure To Install A Protective Fuse For Slave Relay Number 1 In The Engine Supervisory System (ESS) Panel {1900}

1996/09/23 Recommended Customer Communications Module (CCM) Electrical Power Source {1926}

1996/09/23 Help Available For PC Based Service Tools Used For All Electronic Engines {1902}

1996/10/01 Improved Breather Vent Helps Prevent Water Entry Into Altronic III Magnetos{1552}

1996/10/01 Improved Marine Engine Inlet Valves{1105}

1996/10/01 Improvements To Prevent Water From Entering The Flywheel Housing{1157}

1996/10/01 Three Ring Piston Body Assembly Available To Replace The Two Ring Piston Body Assembly{1214}

1996/10/01 An Improved O-Ring Seal And Proper Use Of Adapter Locks Reduces Oil Leaks{1252}

1996/10/01 Conversion Gas Valve Kits Available{1278}

1996/10/01 Improved Oil Cooler Core Assembly{1378}

1996/10/01 Marine Engine Reverse Rotation Harness Code{1408}

1996/10/01 Increased Data Link Limit{1901,1926,1927,7490}