Inlet Air Temperature Sensor - Remove and Install
- Disconnect harness assembly (1) and remove inlet air temperature sensor (2).
Show/hide table
| |
| Illustration 1 | g03038258 |
- Install the inlet air temperature sensor (2) in the reverse order of removal.
- Tighten inlet air temperature sensor to a torque of
20 ± 3 N·m (15 ± 2 lb ft) .
- Tighten inlet air temperature sensor to a torque of
Caterpillar Information System:
2012/05/16 New Oil Level Gauges Are Used on Certain C7 Commercial Engines {1326}
Investigation of Fault or Dropped Load on UPSB125/130 Systems{4480} Investigation of Fault or Dropped Load on UPSB125/130 Systems{4480}
C7.1 Industrial Engine DEF Dosing Control System
C7.1 Industrial Engine Clean Emissions Module
C7.1 Industrial Engine Introduction
C13-XQ350 Rental Generator Set Product Description
C32 Marine Engines Speed/Timing Sensor - Remove and Install
ES12F, UPS 1000S and UPS 1200S Uninterruptible Power Supplys Maintenance Interval Schedule
2013/03/12 Bearing Service Interval Is Extended for Certain Uninterruptible Power Supplies {4480, 7551}
C9.3 Tier 4 Final Engines Speed/Timing - Test
320 VH and VM Variable Gauge Undercarriage Final Drive - Disassemble
320 VH and VM Variable Gauge Undercarriage Final Drive - Assemble
C32 Marine Engines Alternator - Remove and Install
C32 Marine Engines Electric Starting Motor - Remove and Install
C9.3 Tier 4 Final Engines Injector Solenoid - Test
325 VM and VH Variable Gauge Undercarriage Final Drive - Assemble
C13, C15, and C18 Tier 4 Final Engines Fuel Filter Is Restricted
C18 Marine Engines Fuel Transfer Pump - Remove and Install
Failure of Speed/Timing Sensors on C175-16 Generator Set Engines{1907, 1907} Failure of Speed/Timing Sensors on C175-16 Generator Set Engines{1907, 1907}
C9.3 Tier 4 Final Engines Fuel Injection Pump - Test
C9.3 Tier 4 Final Engines Fuel Rail Pressure Is Low
C9.3 Tier 4 Final Engines Fuel Rail Pressure Is Low While Cranking
C9.3 Tier 4 Final Engines Fuel Rail Pressure Leakage Is High
2012/07/31 New Software Is Used for Certain G3516 Engines with the ADEM 3 Electronic Control Module (ECM) and NO<SUB>x</SUB> Feedback {1901, 1920}