New Oil Level Gauges Are Used on Certain C7 Commercial Engines {1326}
- Engine:
- C7 (S/N: JTF1-UP)
- Petroleum Engine:
- C7 (S/N: C7P1-UP)
Description of Change: The new oil level gauge provides increased accuracy of the engine oil level.
Adaptable To: The new 6I-2688 Oil Level Gauge (Dipstick) is a direct replacement for the existing 106-8634 Oil Level Gauge (Dipstick). Refer to Table 1 for the information on the gauge groups and oil pans that the new gauges are used. This change is adaptable back to first production on the serial numbers listed above.
Show/hide table
Gauge Group Part Number     | Gauge Location     | Used with Oil Pan Part Number     |
376-4948     | Left Rear     | 126-5931     |
386-0212     | Right Front     | 300-5531     |
385-9084     | Right Rear     | 117-5123     |
386-0213     | Dual Rear     | 194-9571     |
Show/hide table
Effective Serial Numbers     |
S/N:C7P252-UP     |
S/N:JTF16570-UP     |
Caterpillar Information System:
Investigation of Fault or Dropped Load on UPSB125/130 Systems{4480} Investigation of Fault or Dropped Load on UPSB125/130 Systems{4480}
C7.1 Industrial Engine DEF Dosing Control System
C7.1 Industrial Engine Clean Emissions Module
C7.1 Industrial Engine Introduction
C13-XQ350 Rental Generator Set Product Description
C32 Marine Engines Speed/Timing Sensor - Remove and Install
ES12F, UPS 1000S and UPS 1200S Uninterruptible Power Supplys Maintenance Interval Schedule
2013/03/12 Bearing Service Interval Is Extended for Certain Uninterruptible Power Supplies {4480, 7551}
C9.3 Tier 4 Final Engines Speed/Timing - Test
320 VH and VM Variable Gauge Undercarriage Final Drive - Disassemble
320 VH and VM Variable Gauge Undercarriage Final Drive - Assemble
2012/07/23 Improved Hose Assemblies Are Now Used on Certain C27 and C32 Petroleum Engines {1307, 1308}
C32 Marine Engines Inlet Air Temperature Sensor - Remove and Install
C32 Marine Engines Alternator - Remove and Install
C32 Marine Engines Electric Starting Motor - Remove and Install
C9.3 Tier 4 Final Engines Injector Solenoid - Test
325 VM and VH Variable Gauge Undercarriage Final Drive - Assemble
C13, C15, and C18 Tier 4 Final Engines Fuel Filter Is Restricted
C18 Marine Engines Fuel Transfer Pump - Remove and Install
Failure of Speed/Timing Sensors on C175-16 Generator Set Engines{1907, 1907} Failure of Speed/Timing Sensors on C175-16 Generator Set Engines{1907, 1907}
C9.3 Tier 4 Final Engines Fuel Injection Pump - Test
C9.3 Tier 4 Final Engines Fuel Rail Pressure Is Low
C9.3 Tier 4 Final Engines Fuel Rail Pressure Is Low While Cranking
C9.3 Tier 4 Final Engines Fuel Rail Pressure Leakage Is High