Fuel Transfer Pump - Remove and Install
Show/hide table
Required Tools | |||
Tool | Part Number | Part Description | Qty |
A | 207-1600(1) | Rubber Lubricant | 1 |
207-1601 | Rubber Lubricant | 1 |
Show/hide table
(1) | For use in EAME |
- Turn the fuel supply to the “OFF” position.
- Remove the alternator and damper guard.
Show/hide table
Illustration 1 g03039774 - Disconnect tube assembly (2) and remove the adapter.
- Remove adapter assembly (4) and bolts (1).
- Remove fuel transfer pump (3) discard the O-ring seal. Use a new O-ring seal for installation.
- Install fuel transfer pump (3) in the reverse order of removal.
- Apply Tooling (A) to the O-ring seal for fuel transfer pump (3).
- Tighten bolts (1) to a torque of
47 ± 9 N·m (34.7 ± 6.6 lb ft) .
Caterpillar Information System:
C13, C15, and C18 Tier 4 Final Engines Fuel Filter Is Restricted
325 VM and VH Variable Gauge Undercarriage Final Drive - Assemble
C9.3 Tier 4 Final Engines Injector Solenoid - Test
C32 Marine Engines Electric Starting Motor - Remove and Install
C32 Marine Engines Alternator - Remove and Install
C32 Marine Engines Inlet Air Temperature Sensor - Remove and Install
2012/05/16 New Oil Level Gauges Are Used on Certain C7 Commercial Engines {1326}
Investigation of Fault or Dropped Load on UPSB125/130 Systems{4480} Investigation of Fault or Dropped Load on UPSB125/130 Systems{4480}
C7.1 Industrial Engine DEF Dosing Control System
C7.1 Industrial Engine Clean Emissions Module
C7.1 Industrial Engine Introduction
C13-XQ350 Rental Generator Set Product Description
Failure of Speed/Timing Sensors on C175-16 Generator Set Engines{1907, 1907} Failure of Speed/Timing Sensors on C175-16 Generator Set Engines{1907, 1907}
C9.3 Tier 4 Final Engines Fuel Injection Pump - Test
C9.3 Tier 4 Final Engines Fuel Rail Pressure Is Low
C9.3 Tier 4 Final Engines Fuel Rail Pressure Is Low While Cranking
C9.3 Tier 4 Final Engines Fuel Rail Pressure Leakage Is High
2012/07/31 New Software Is Used for Certain G3516 Engines with the ADEM 3 Electronic Control Module (ECM) and NO<SUB>x</SUB> Feedback {1901, 1920}
3512C and 3516C Marine Engines Turbocharger
3512B, 3512C, and 3516B Generator Set Engines with Dynamic Gas Blending Restriction of Air Inlet and Exhaust
C7.1 Industrial Engine Cooling System
3512C and 3516C Marine Engines Fumes Disposal System
UPS 250, UPS 300, UPS 301, UPS 500, UPS 600, UPS 750 and UPS 900 Uninterruptible Power Supplies Bearing (Earlier) - Replace
UPS 250, UPS 300, UPS 301, UPS 500, UPS 600, UPS 750 and UPS 900 Uninterruptible Power Supplies Bearing (3.5 EVD or Greater) - Replace