Maintenance Interval Schedule
When Required
Air Filter - ReplaceFlywheel - Clean
Oil Level - Check
Sight Gauge - Clean
Every Year
Oil - ChangeEvery 3 Years
Bearing (Earlier) - ReplaceEvery 4 Years
Bearing (3.5 EVD or Greater) - ReplaceEvery 5 Years
Battery - ReplaceBattery - Replace
Caterpillar Information System:
2013/03/12 Bearing Service Interval Is Extended for Certain Uninterruptible Power Supplies {4480, 7551}
C9.3 Tier 4 Final Engines Speed/Timing - Test
320 VH and VM Variable Gauge Undercarriage Final Drive - Disassemble
320 VH and VM Variable Gauge Undercarriage Final Drive - Assemble
2012/07/23 Improved Hose Assemblies Are Now Used on Certain C27 and C32 Petroleum Engines {1307, 1308}
C13-XQ350 Rental Generator Set Starting the Engine
C32 Marine Engines Fuel Temperature Sensor - Remove and Install
C13, C15, and C18 Tier 4 Final Engines SCR Warning System Problem
TH48-E80 Petroleum Transmission Selector and Pressure Control Valve (Transmission)
C9.3 Tier 4 Final Engines Power Is Intermittently Low or Power Cutout Is Intermittent
C32 Marine Engines Fuel Pressure Sensor - Remove and Install
C9.3 Tier 4 Final Engines Oil Contains Fuel
C32 Marine Engines Speed/Timing Sensor - Remove and Install
C13-XQ350 Rental Generator Set Product Description
C7.1 Industrial Engine Introduction
C7.1 Industrial Engine Clean Emissions Module
C7.1 Industrial Engine DEF Dosing Control System
Investigation of Fault or Dropped Load on UPSB125/130 Systems{4480} Investigation of Fault or Dropped Load on UPSB125/130 Systems{4480}
2012/05/16 New Oil Level Gauges Are Used on Certain C7 Commercial Engines {1326}
C32 Marine Engines Inlet Air Temperature Sensor - Remove and Install
C32 Marine Engines Alternator - Remove and Install
C32 Marine Engines Electric Starting Motor - Remove and Install
C9.3 Tier 4 Final Engines Injector Solenoid - Test
325 VM and VH Variable Gauge Undercarriage Final Drive - Assemble