Fuel Pressure Sensor - Remove and Install
Show/hide table
| NOTICE |
|---|
|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
| NOTICE |
|---|
|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products. Dispose of all fluids according to local regulations and mandates. |
- Disconnect harness assembly (1) and remove fuel pressure sensor (2).
Show/hide table
| |
| Illustration 1 | g03032896 |
(1) Fuel pressure sensor ...
- Install fuel pressure sensor (2) in the reverse order of removal.
- Tighten fuel pressure sensor (2) to a torque of
10 ± 2 N·m (89 ± 18 lb in) .
- Tighten fuel pressure sensor (2) to a torque of
Caterpillar Information System:
C9.3 Tier 4 Final Engines Oil Contains Fuel
C9.3 Tier 4 Final Engines Fuel Temperature Is High
C13, C15, and C18 Tier 4 Final Engines Fuel Pressure Is Low
C9.3 Tier 4 Final Engines Fuel Pressure Is High
C9.3 Tier 4 Final Engines Fuel Consumption Is Excessive
2012/07/23 New Software Is Used for Certain G3516C Engines {1901, 1920}
C175-16 Engine for 795F Series AC Off-Highway Trucks Housing (Front)
2012/08/03 New Thermostats Are Now Used for Jacket Water Heater on Certain Cat Gensets and Cat Engines {1383}
C32 Marine Engines Engine Oil Pressure Sensor - Remove and Install
325 VM and VH Variable Gauge Undercarriage Final Drive - Disassemble
C9.3 Tier 4 Final Engines Engine Cranks but Does Not Start
G3516C and G3516E Gas Engines Exhaust Manifold
C9.3 Tier 4 Final Engines Power Is Intermittently Low or Power Cutout Is Intermittent
TH48-E80 Petroleum Transmission Selector and Pressure Control Valve (Transmission)
C13, C15, and C18 Tier 4 Final Engines SCR Warning System Problem
C32 Marine Engines Fuel Temperature Sensor - Remove and Install
C13-XQ350 Rental Generator Set Starting the Engine
2012/07/23 Improved Hose Assemblies Are Now Used on Certain C27 and C32 Petroleum Engines {1307, 1308}
320 VH and VM Variable Gauge Undercarriage Final Drive - Assemble
320 VH and VM Variable Gauge Undercarriage Final Drive - Disassemble
C9.3 Tier 4 Final Engines Speed/Timing - Test
2013/03/12 Bearing Service Interval Is Extended for Certain Uninterruptible Power Supplies {4480, 7551}
ES12F, UPS 1000S and UPS 1200S Uninterruptible Power Supplys Maintenance Interval Schedule
C32 Marine Engines Speed/Timing Sensor - Remove and Install