Fuel Temperature Sensor - Remove and Install
拆卸步骤
- 断开线束组件 (1) 后拆下燃油温度传感器 (2) 。
Show/hide table
图 1 | g02104923 |
安装步骤
- 按与拆卸相反的顺序安装燃油温度传感器 (2) 。
- 将燃油温度传感器 (2) 上紧到 20 ± 3 N·m (177 ± 27 lb in) 的扭矩。
Caterpillar Information System:
C18 Generator Set Generator Bearing - Lubricate
3508C, 3512C and 3516C Marine Engines Heat Exchanger - Disassemble
C18 Generator Set Generator Start-up Checklist
2010/02/19 A New Tool is Available to Test and Adjust the Setting of the Main Relief Valve and the Line Relief Valves for Certain Excavators {0784, 5051, 5069, 5117}
G3516C and G3516E Gas Engines Jacket Water Heater
C175-16 Petroleum Engines Fuel Injection Pump
C18 Generator Set Plate Locations and Film Locations
C15 and C18 Engines for Caterpillar Built Machines Boost Pressure Sensor - Remove and Install
EMCP4.1/EMCP4.2 Output Programming
349F and 352F Excavators Camera Harness - Disconnect and Connect
2010/06/25 A New Water Connection Gp Is Used on C32 Engines that Are Keel Cooled {1380}
C15 and C18 Industrial Engines Engine Control Module - Remove and Install
C18 Generator Set Product Installation
C15 and C18 Industrial Engines Fuel Pressure Sensor - Remove and Install
C15 and C18 Industrial Engines Coolant Temperature Sensor - Remove and Install
3508C, 3512C and 3516C Marine Engines Heat Exchanger - Assemble
3508C, 3512C and 3516C Marine Engines Heat Exchanger - Assemble
C15 and C18 Engines Product Description
EMCP4.1/EMCP4.2 Analog Input Programming
G3500B Engines Air Starting Control
C175-16 Marine Propulsion Engines Air Lines
G3500B Engines Air Lines
C175-16 Marine Propulsion Engines Air Lines
G3500B Engines Air Starting Control