Plate Locations and Film Locations
Show/hide table
Illustration 1 | g02103424 |
Note: For quick reference, record the appropriate information in the spaces that are provided below.
Serial Number Plate for the Generator (1)
The generator identification is located on the side of the generator.
The generator identification film includes the following information:
- Serial number for the generator ____________________
- Generator model number ____________________
The Engine Serial Number Plate is on the lower right side of the cylinder block near the rear of the engine.
The Engine Serial Number Plate contains the following information:
- Engine serial number ____________________
- Engine model number ____________________
- Arrangement number ____________________
The Engine Information Plate is on the valve cover.
The Engine Information Plate contains the following information:
- Engine serial number ____________________
- Arrangement number ____________________
- Compression ratio ____________________
- Aftercooler temperature ____________________
- Power ____________________
- Full load RPM ____________________
Caterpillar Information System:
C15 and C18 Engines for Caterpillar Built Machines Boost Pressure Sensor - Remove and Install
EMCP4.1/EMCP4.2 Output Programming
349F and 352F Excavators Camera Harness - Disconnect and Connect
2010/06/25 A New Water Connection Gp Is Used on C32 Engines that Are Keel Cooled {1380}
C15 and C18 Industrial Engines Engine Control Module - Remove and Install
C27 Generator Set Engines Vibration Damper and Pulley
C13 Engine for Combat and Tactical Vehicles Main Bearing Journal
C9.3 Tier 4 Interim Engines Speed Control (PTO) - Test
C4.4 Industrial Engine Engine Operation
CX35-P800 Petroleum Transmission Maintenance Interval Schedule
CB22B, CB24B, CB32B and CC24B Utility Compactors Film (Product Identification) - Clean
3512C Petroleum Engines Fuel Filter Differential Pressure - Check
C175-16 Petroleum Engines Fuel Injection Pump
G3516C and G3516E Gas Engines Jacket Water Heater
2010/02/19 A New Tool is Available to Test and Adjust the Setting of the Main Relief Valve and the Line Relief Valves for Certain Excavators {0784, 5051, 5069, 5117}
C18 Generator Set Generator Start-up Checklist
3508C, 3512C and 3516C Marine Engines Heat Exchanger - Disassemble
C18 Generator Set Generator Bearing - Lubricate
C15 and C18 Industrial Engines Fuel Temperature Sensor - Remove and Install
C18 Generator Set Product Installation
C15 and C18 Industrial Engines Fuel Pressure Sensor - Remove and Install
C15 and C18 Industrial Engines Coolant Temperature Sensor - Remove and Install
3508C, 3512C and 3516C Marine Engines Heat Exchanger - Assemble
3508C, 3512C and 3516C Marine Engines Heat Exchanger - Assemble