Generator Bearing - Lubricate
Lubricating Process (If Applicable)
Show/hide table
Illustration 1 | g02104717 |
- Remove the louver assembly (4) from the side of the generator.
- Remove the rear plate (1) from the rear of the generator housing.
- Remove the upper grease pipe plug (3) .
- Remove the lower grease pipe plug (2) .
Show/hide table
Illustration 2 | g02104594 |
- Install a grease fitting into the upper grease pipe (3) .
- Install a grease fitting into the lower grease pipe (2) .
- Grease the bearings with the appropriate grease. Refer to table 1.
Note: Do not mix greases.
Show/hide table
Part number of the bearing     | Type of bearing     | Frame size     | Minimum temperature Maximum temperature     |
Part number of the grease     | Interval     | Weight     | Volume     | Shaft diameter     |
5P-2448 Ball Bearing     | 315BC 160 mm (6.3 inch) OD 75 mm (3 inch) ID     |
580/590     | 29° C (84.2° F) minimum temperature 80° C (176° F) maximum temperature     |
2S-3230 Bearing Lubricant     | Every 2000 service hours or 12 months     | 51.2 gram (1.8 ounce)     |
59 mL (2 oz)     |
75 mm (3 inch)     |
Caterpillar Information System:
3508C, 3512C and 3516C Marine Engines Heat Exchanger - Disassemble
C18 Generator Set Generator Start-up Checklist
2010/02/19 A New Tool is Available to Test and Adjust the Setting of the Main Relief Valve and the Line Relief Valves for Certain Excavators {0784, 5051, 5069, 5117}
G3516C and G3516E Gas Engines Jacket Water Heater
C175-16 Petroleum Engines Fuel Injection Pump
C18 Generator Set Plate Locations and Film Locations
C15 and C18 Engines for Caterpillar Built Machines Boost Pressure Sensor - Remove and Install
EMCP4.1/EMCP4.2 Output Programming
349F and 352F Excavators Camera Harness - Disconnect and Connect
2010/06/25 A New Water Connection Gp Is Used on C32 Engines that Are Keel Cooled {1380}
C15 and C18 Industrial Engines Engine Control Module - Remove and Install
C27 Generator Set Engines Vibration Damper and Pulley
C15 and C18 Industrial Engines Fuel Temperature Sensor - Remove and Install
C18 Generator Set Product Installation
C15 and C18 Industrial Engines Fuel Pressure Sensor - Remove and Install
C15 and C18 Industrial Engines Coolant Temperature Sensor - Remove and Install
3508C, 3512C and 3516C Marine Engines Heat Exchanger - Assemble
3508C, 3512C and 3516C Marine Engines Heat Exchanger - Assemble
C15 and C18 Engines Product Description
EMCP4.1/EMCP4.2 Analog Input Programming
G3500B Engines Air Starting Control
C175-16 Marine Propulsion Engines Air Lines
G3500B Engines Air Lines
C175-16 Marine Propulsion Engines Air Lines