Engine Control Module - Remove and Install
拆卸步骤
- 断开蓄电池。 请参阅操作和保养手册, "蓄电池或蓄电池电缆 - 断开"。
- 拆下螺母 (1) 。
Show/hide table
图 1 | g02103128 |
- 松开内六角螺栓 (2) 后将线束组件放到一旁。
- 断开软管组件 (4) 和 (5) 。
- 拆下螺柱 (3) 。 拆下发动机控制模块、垫圈和隔离安装件。
安装步骤
- 按相反顺序安装发动机控制模块。
- 将内六角螺栓 (2) 上紧到 6 ± 1 N·m (53 ± 9 lb in) 的扭矩。
Caterpillar Information System:
C27 Generator Set Engines Vibration Damper and Pulley
C13 Engine for Combat and Tactical Vehicles Main Bearing Journal
C9.3 Tier 4 Interim Engines Speed Control (PTO) - Test
C4.4 Industrial Engine Engine Operation
CX35-P800 Petroleum Transmission Maintenance Interval Schedule
CB22B, CB24B, CB32B and CC24B Utility Compactors Film (Product Identification) - Clean
3512C Petroleum Engines Fuel Filter Differential Pressure - Check
Conversion Procedure for Frequency on the C32 Power Module{1901, 4490, 7002} Conversion Procedure for Frequency on the C32 Power Module{1901, 4490, 7002}
G3306B Generator Sets Crankcase Blowby - Test/Record
C27 PET GEN SET Electric Power Generation and C27 KNOCKDOWN K Petroleum Power Train Package Varistor - Inspect
G3500 Generator Sets Space Heater - Test
C13 Tier 4 Final Engines Fan Drive
2010/06/25 A New Water Connection Gp Is Used on C32 Engines that Are Keel Cooled {1380}
349F and 352F Excavators Camera Harness - Disconnect and Connect
EMCP4.1/EMCP4.2 Output Programming
C15 and C18 Engines for Caterpillar Built Machines Boost Pressure Sensor - Remove and Install
C18 Generator Set Plate Locations and Film Locations
C175-16 Petroleum Engines Fuel Injection Pump
G3516C and G3516E Gas Engines Jacket Water Heater
2010/02/19 A New Tool is Available to Test and Adjust the Setting of the Main Relief Valve and the Line Relief Valves for Certain Excavators {0784, 5051, 5069, 5117}
C18 Generator Set Generator Start-up Checklist
3508C, 3512C and 3516C Marine Engines Heat Exchanger - Disassemble
C18 Generator Set Generator Bearing - Lubricate
C15 and C18 Industrial Engines Fuel Temperature Sensor - Remove and Install