Maintenance Interval Schedule
需要时即进行的保养
呼吸器(变速箱) - 清洁每 10 个工作小時数
变速箱油油位 – 检查初次100工作小时
油滤清器 (变速箱) - 更换每500个工作小时或 6 个月
呼吸器(变速箱) - 清洁磁性滤网(变速箱) – 清洁
油滤清器 (变速箱) - 更换
变速箱油 – 更换
变速箱油样 - 采样
每 1500 个工作小时数或 1 年
呼吸器(变速箱) - 清洁Caterpillar Information System:
CB22B, CB24B, CB32B and CC24B Utility Compactors Film (Product Identification) - Clean
3512C Petroleum Engines Fuel Filter Differential Pressure - Check
Conversion Procedure for Frequency on the C32 Power Module{1901, 4490, 7002} Conversion Procedure for Frequency on the C32 Power Module{1901, 4490, 7002}
G3306B Generator Sets Crankcase Blowby - Test/Record
C27 PET GEN SET Electric Power Generation and C27 KNOCKDOWN K Petroleum Power Train Package Varistor - Inspect
G3500 Generator Sets Space Heater - Test
C13 Tier 4 Final Engines Fan Drive
EMCP4.1/EMCP4.2 Setpoint Programming
C175-16 PETROLEUM ENGINES Auxiliary Water Pump - Assemble
C175-16 and C175-20 Engines for Caterpillar Built Machines Water Pump - Assemble
3524B Engine for Caterpillar Built Machines Water Pump - Disassemble
C27 and C32 Industrial Engines Diagnostic Flash Code Retrieval
C4.4 Industrial Engine Engine Operation
C9.3 Tier 4 Interim Engines Speed Control (PTO) - Test
C13 Engine for Combat and Tactical Vehicles Main Bearing Journal
C27 Generator Set Engines Vibration Damper and Pulley
C15 and C18 Industrial Engines Engine Control Module - Remove and Install
2010/06/25 A New Water Connection Gp Is Used on C32 Engines that Are Keel Cooled {1380}
349F and 352F Excavators Camera Harness - Disconnect and Connect
EMCP4.1/EMCP4.2 Output Programming
C15 and C18 Engines for Caterpillar Built Machines Boost Pressure Sensor - Remove and Install
C18 Generator Set Plate Locations and Film Locations
C175-16 Petroleum Engines Fuel Injection Pump
G3516C and G3516E Gas Engines Jacket Water Heater