Coolant Temperature Sensor - Remove and Install
Removal Procedure
Note: The coolant temperature sensor is located in the water temperature regulator housing.
- Drain the coolant from the cooling system to a level below the coolant temperature sensor into a suitable container for storage or disposal.
- Disconnect harness assembly (1) and remove coolant temperature sensor (2) .
Show/hide table
Illustration 1 | g02105054 |
- Remove the O-ring seal from the coolant temperature sensor.
Installation Procedure
- Install the coolant temperature sensor in the reverse order.
- Tighten coolant temperature sensor (2) to a torque of 20 ± 3 N·m (177 ± 27 lb in).
Note: Do not pre-tighten the sensor using the plastic portion of the sensor. Pre-tighten the sensor using the metal hex portion of the sensor. Damage can occur to the sensor if pre-tightened using the plastic portion of the sensor.
- Fill the cooling system with coolant. Refer to Operation and Maintenance, "Refill Capacities" for the cooling system capacity.
Caterpillar Information System:
C15 and C18 Industrial Engines Fuel Pressure Sensor - Remove and Install
C18 Generator Set Product Installation
C15 and C18 Industrial Engines Fuel Temperature Sensor - Remove and Install
C18 Generator Set Generator Bearing - Lubricate
3508C, 3512C and 3516C Marine Engines Heat Exchanger - Disassemble
C18 Generator Set Generator Start-up Checklist
2010/02/19 A New Tool is Available to Test and Adjust the Setting of the Main Relief Valve and the Line Relief Valves for Certain Excavators {0784, 5051, 5069, 5117}
G3516C and G3516E Gas Engines Jacket Water Heater
C175-16 Petroleum Engines Fuel Injection Pump
C18 Generator Set Plate Locations and Film Locations
C15 and C18 Engines for Caterpillar Built Machines Boost Pressure Sensor - Remove and Install
EMCP4.1/EMCP4.2 Output Programming
3508C, 3512C and 3516C Marine Engines Heat Exchanger - Assemble
3508C, 3512C and 3516C Marine Engines Heat Exchanger - Assemble
C15 and C18 Engines Product Description
EMCP4.1/EMCP4.2 Analog Input Programming
G3500B Engines Air Starting Control
C175-16 Marine Propulsion Engines Air Lines
G3500B Engines Air Lines
C175-16 Marine Propulsion Engines Air Lines
G3500B Engines Air Starting Control
C27 and C32 Engines for Caterpillar Built Machines Oil Contains Fuel
C13 Tier 4 Final Engines Engine Support (Front)