TH55FT-E70 and TH55FT-E90 Transmissions Caterpillar


Lifting and Tying Down the Transmission

Usage:

TH55-E70 PCJ

起吊




图 1g00103219


注意

千万不要折弯吊环螺栓和支架。 吊环螺栓和支架只能承受张力负荷。 要记住当支承构件和物体之间的角度小于90°时,吊环螺栓的承载能力变小。

当必须在某一角度搬移部件时,只能使用具有适当额定载荷的连杆支架。


使用起重机搬移重的部件。 使用可调的吊梁起吊变速箱。 所有的支承构件(链条和钢丝绳)应互相平行。 链条和钢丝绳与被吊物的顶面尽可能保持垂直。 改动吊耳或夹紧装置会使吊耳或吊装工具失效。

有些搬移工作要求用吊装工具吊装,以确保平衡和安全。




图 2g02126021

TH55 变速箱

(1) 吊耳(三个)

起吊物料时,使用正确额定值的钢索和正确额定值的吊具。 安置起重机以便水平起吊变速箱。 有关正确起吊变速箱所需的吊装工具资料,请咨询您的 Cat 代理商。

变速箱和发动机连接器(带干式油池)的重量约为 3053 kg (6730 lb)。

撑杆宽度应足够防止接触变速箱。

吊耳 (1) 可用于起吊或系紧变速箱。 在所有位置安装系紧绳。 对于完全组装后的变速箱,吊耳 (1) 是批准的唯一起吊点。

系紧

使用变速箱后面的吊耳 (1) 系紧变速箱。 使用一条系带跨过钟形壳体系紧变速箱的前部。 可跨过变矩器壳体在壳体 SAE 适配器螺栓附近使用批准的系带或链条,代替前吊耳系紧变速箱。

Caterpillar Information System:

2008/10/20 EERP1000 Support CD for the PL1000E and PL1000T {7606, 7620}
G3508B, G3512B, G3512B, G3516B and G3520B Petroleum Engines Engine Oil Pan - Install
G3516 Petroleum Engines Engine Oil Pan - Assemble
G3516 Petroleum Engines Engine Oil Pan - Disassemble
Updating the Certification Label for China{7557} Updating the Certification Label for China{7557}
G3508B, G3512B, G3512B, G3516B and G3520B Petroleum Engines Engine Oil Pan - Remove
R250 Automatic Voltage Regulator Load Acceptance Module - Adjust
Procedure to Update the Open Crankcase Ventilation System on C13 and C15 Engines{1074, 1120, 1317} Procedure to Update the Open Crankcase Ventilation System on C13 and C15 Engines{1074, 1120, 1317}
2008/10/20 Glow Plugs {1412}
G3508B, G3512B, G3512B, G3516B and G3520B Petroleum Engines Prelubrication Oil Pump - Remove and Install
G3516 Petroleum Engines Thermostatic Valve - Install
G3516 Petroleum Engines Thermostatic Valve - Remove
G3516 Petroleum Engines Vibration Damper - Remove and Install
3500B Generator Sets Safety Messages
TH55FT-E70 and TH55FT-E90 Transmissions Safety Messages
2008/10/01 A New Fuel Enable Valve Is Now Used {5479}
G3516 Petroleum Engines Crankcase Breather - Remove and Install
3516C Generator Sets Configuration Parameters
Visual Inspection of Main Bearings and Connecting Rod Bearings {1202, 1203, 1225, 1230} Visual Inspection of Main Bearings and Connecting Rod Bearings {1202, 1203, 1225, 1230}
R250 Automatic Voltage Regulator Stability - Adjust
R250 Automatic Voltage Regulator Voltage - Adjust
R250 Automatic Voltage Regulator Remote Voltage Control
TH55FT-E70 and TH55FT-E90 Transmissions Breather (Transmission) - Clean
3516C HD Generator Set with Gearbox Emergency Stopping
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.