Turbocharger
Show/hide table
Illustration 1 | g01460889 |
Typical example Rear view of engine |
(1) Apply 4C-5599 Anti-Seize Compound to the threads and the bearing surface of four locknuts before assembly.
Show/hide table
Illustration 2 | g01460237 |
Typical example |
Use the following procedure to tighten the compressor clamp assembly (2) and the turbine clamp assembly (3) for the turbocharger group:
- Tighten the clamp assemblies to
14.0 ± 1.0 N·m (125 ± 9 lb in) . - Lightly tap around the clamp assemblies with a soft faced hammer.
- Again, tighten the clamp assemblies to
14.0 ± 1.0 N·m (125 ± 9 lb in) .
Caterpillar Information System:
C175-16 and C175-20 Generator Set Engines Crankcase Pressure Is High
C175-16 and C175-20 Engines for Off-Highway Trucks Camshaft
3500 Engines Engine Oil Cooler Bypass and Cooling Jet Sequence Valves
C175-16 and C175-20 Generator Set Engines Oil Contains Fuel
3500B Locomotive Engines Configuration Parameters
C4.4 Industrial Engine Engine Rating Conditions
C4.4 Industrial Engine Engine Rating Definitions
3500C Marine Engines Camshaft
C18 Industrial Engines Monitoring System
793F and 793F XQ Off-Highway Truck Fast Fill Service System General Information
345D, 349D and 349D2 Excavators Hydraulic System Swing Hydraulic System
Repairing the Fuel Injector Rocker Arm{1102, 1123, 1290} Repairing the Fuel Injector Rocker Arm{1102, 1123, 1290}
345D, 349D and 349D2 Excavators Hydraulic System Oil Makeup (Swing System)
2008/02/25 A New Oil Filter Group is Now Used on the TH48-E80 Oil/Gas Transmission {3030, 3067}
345D, 349D and 349D2 Excavators Hydraulic System Relief Valve (Cushion Crossover) - Anti-Reaction Valves
2008/06/02 An Improved Alternator Belt Guard Is Now Used {7174}
345D, 349D and 349D2 Excavators Hydraulic System Solenoid Valve (Fine Swing) - If Equipped
3176C, 3406E and 3456 Industrial Engines ECM Software - Install
3176C, 3406E and 3456 Industrial Engines Intake Manifold Air Pressure Is High
345D, 349D and 349D2 Excavators Hydraulic System Travel Hydraulic System
SR5 Electric Power Generation Bus Bar - Remove and Install
C175-16 and C175-20 Generator Set Engines Injector Solenoid - Test
The Idle Shutdown Timer May Cause the Engine to Shut Down During Regenerations Initiated with Caterpillar Electronic Technician (ET){108B} The Idle Shutdown Timer May Cause the Engine to Shut Down During Regenerations Initiated with Caterpillar Electronic Technician (ET){108B}
C15 Petroleum Generator Set Engines Speed Sensor