Governor Drive - Assemble - Earlier
Assembly Procedure
Show/hide table
Required Tools     | |||
Tool     | Part Number     | Part Description     | Qty     |
A     | 1P-0510     | Driver Group     | 1     |
Note: Use 8T-0447 Dial Calipers to measure the dimensions in the following procedure.
- If the bearing was removed from housing (4), Use Tooling (A) and install the bearing in the housing. The inside diameter of the bearing must be 24.993 ± 0.033 mm (0.9840 ± 0.0013 inch).
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Note: Refer to Disassembly and Assembly, "General Information (Reference Material)" for more information.
Show/hide table
Illustration 1 | g00627067 |
- Place pinion (3) in position in housing (4). Install thrust washer (2) and the bolts that hold the thrust washer in place.
- Place coupling (1) in position on pinion (3) .
End By: Install the governor drive. Refer to Disassembly and Assembly, "Governor Drive - Install".
Caterpillar Information System:
3176C, 3406E and 3456 Industrial Engines Fuel Temperature Is High
3176C, 3406E and 3456 Industrial Engines Fuel Pressure Problem
G3500 Engines Nitrogen Oxide Sensor - Calibrate
C15 and C18 Petroleum Engines Engine Design
C15 and C18 Petroleum Engines Turbocharger Oil Lines
G3500B Engines Nitrogen Oxide Sensor - Calibrate
Manual Programming of a UPS System{4480, 7620} Manual Programming of a UPS System{4480, 7620}
Procedure for Using the Automatic Flash Update Tool for a UPS System{4480, 7620} Procedure for Using the Automatic Flash Update Tool for a UPS System{4480, 7620}
G3520C and G3520E Engines Turbocharger
Procedure to Relocate the Inlet Hose for the ARD Purge Air Pump{107P, 1803} Procedure to Relocate the Inlet Hose for the ARD Purge Air Pump{107P, 1803}
C15 and C18 Petroleum Engines Turbocharger Oil Lines
3608 Engine Valve Lifter - Assemble
3176C, 3406E and 3456 Industrial Engines Intake Manifold Air Temperature Is High
3608 Engine Fuel Transfer Pump - Assemble
3176C, 3406E and 3456 Industrial Engines Oil Pressure Is Low
2007/12/03 Cylinder Head Gasket {1100, 1251}
3608 Engine Valve Lifter - Install
2008/12/08 Procedure for Cleaning the Power Train {3065, 3139}
3176C, 3406E and 3456 Industrial Engines Electrical Power Supply - Test
3608 Engine Air Starting Motor - Remove
3608 Engine Water Pump - Disassemble
3608 Engine Auxiliary Water Pump - Remove
3608 Engine Auxiliary Water Pump - Disassemble
2008/01/01 Use the Correct Fittings for the Fuel Manifold {1274, 1380}