Valve Mechanism Cover - Remove and Install
Removal Procedure
- Disconnect harness assemblies (1). Loosen clamp assembly (2) and position the hose out of the way.
Show/hide table
Illustration 1 | g01356210 |
- Loosen clamps (5) and position tube assembly (4) out of the way.
Show/hide table
Illustration 2 | g01354312 |
- Remove nuts (6) .
- Remove bolts (7) and remove valve mechanism cover (8) .
Installation Procedure
- Position valve mechanism cover (8) and install bolts (7) .
Note: Check the O-ring seals, the gaskets, and the seals for wear or for damage. Replace the components, if necessary.
Show/hide table
Illustration 3 | g01354312 |
- Install nuts (6) .
- Position tube assembly (4) and tighten clamps (5) .
- Position hose (3) and tighten clamp (2). Connect harness assemblies (1) .
Show/hide table
Illustration 4 | g01356210 |
Caterpillar Information System:
3508C, 3512C and 3516C Marine Engines Water Pump - Remove
2007/02/01 New Improved Air Lines for Air Compressors Are Now Used {5502}
2009/10/05 New Improved Air Lines for Air Compressors Are Now Used on C15 and C18 Industrial Engines {5502}
3508C, 3512C and 3516C Marine Engines Exhaust Manifold - Remove and Install
C9 On-highway Engine Valve Mechanism Cover
Replacing the Combustion Head for the Aftertreatment Regeneration Device{1088, 1720, 1722} Replacing the Combustion Head for the Aftertreatment Regeneration Device{1088, 1720, 1722}
C4.4 (Mech) Industrial Engine Fuel System Primary Filter/Water Separator - Drain
C4.4 (Mech) Industrial Engine Fuel System Secondary Filter - Replace
C3.4 Engines for Caterpillar Built Machines Piston and Rings
3508C, 3512C and 3516C Marine Engines Exhaust Elbow - Remove and Install
C11 and C13 On-Highway Engines Gear Group (Rear)
3508C, 3512C and 3516C Marine Engines Air Inlet Manifold - Remove and Install
C7 and C9 On-Highway Engines Engine Monitoring Lamp Parameters
C9 On-highway Engine Rocker Arm and Shaft - Remove
CX35 On-Highway Transmission Transmission Planetary - Assemble
2007/02/01 Retirement of the Paper Version of Truck Engine News {1000}
G3516B and G3520B Generator Set Engines Engine Oil Pan - Remove
C9.3 Engines for Caterpillar Built Machines Rocker Arm and Shaft - Install
G3516B and G3520B Generator Set Engines Engine Oil Pan - Install
C4.4 and C6.6 Engines for Caterpillar Built Machines 5 Volt Sensor Supply Circuit - Test
G3516B and G3520B Generator Set Engines Electric Starting Motor - Remove and Install
3508C, 3512C and 3516C Marine Engines Water Pump - Install
3512B and 3516B High Displacement Locomotive Engines Maintenance Recommendations
C9 On-highway Engine Unit Injector - Install