Electric Starting Motor - Remove and Install
- Disconnect the cable assemblies from solenoid (1) and electric starting motor (2).
If the engine has two electric starting motors, disconnect the cable assemblies between the two solenoids and the electric starting motors.
- Attach a suitable lifting device to electric starting motor (2). The weight of electric starting motor is approximately
30 kg (66 lb) . - Remove three bolts (3). Remove electric starting motor (2). Remove the gasket from the joint between electric starting motor (2) and the flywheel housing.
Show/hide table
Disconnect batteries before performance of any service work. |
Note: Before disconnecting the cable assemblies, mark the items for the proper connections in order to ensure correct assembly.
Show/hide table
Illustration 1 | g00597378 |
- Inspect the gasket for the joint between the electric starting motor and the flywheel housing. Obtain a new gasket, if necessary.
Show/hide table
Illustration 2 g00597378 - Attach a suitable lifting device to electric starting motor (2). The weight of electric starting motor (2) is approximately
30 kg (66 lb) . - Place the gasket in the cover for electric starting motor (2). Lift electric starting motor (2) onto the mounting position. Install three bolts (3).
- Connect the cable assemblies to solenoid (1) and electric starting motor (2).
If the engine has two electric starting motors, connect the cable assemblies between the two solenoids and the electric starting motors.
Caterpillar Information System:
C4.4 and C6.6 Engines for Caterpillar Built Machines 5 Volt Sensor Supply Circuit - Test
G3516B and G3520B Generator Set Engines Engine Oil Pan - Install
C9.3 Engines for Caterpillar Built Machines Rocker Arm and Shaft - Install
G3516B and G3520B Generator Set Engines Engine Oil Pan - Remove
2007/02/01 Retirement of the Paper Version of Truck Engine News {1000}
CX35 On-Highway Transmission Transmission Planetary - Assemble
C9 On-highway Engine Rocker Arm and Shaft - Remove
C7 and C9 On-Highway Engines Engine Monitoring Lamp Parameters
C9 On-highway Engine Valve Mechanism Cover - Remove and Install
3508C, 3512C and 3516C Marine Engines Water Pump - Remove
2007/02/01 New Improved Air Lines for Air Compressors Are Now Used {5502}
2009/10/05 New Improved Air Lines for Air Compressors Are Now Used on C15 and C18 Industrial Engines {5502}
3508C, 3512C and 3516C Marine Engines Water Pump - Install
3512B and 3516B High Displacement Locomotive Engines Maintenance Recommendations
C9 On-highway Engine Unit Injector - Install
G3520C and G3520E Engines Valve Mechanism
2007/04/09 A New Fan Pulley Group is Used {1359}
C9 On-highway Engine Unit Injector - Remove
3500C Marine Auxiliary Engines Boost Pressure Is High
C15 and C18 Industrial Engines Flywheel Housing
C4.4 (Mech) Industrial Engine Fuel Tank Water and Sediment - Drain
2007/03/12 Turbochargers {1052}
3500C Marine Auxiliary Engines Fuel Pressure Is Low
3508C, 3512C and 3516C Marine Engines Auxiliary Water Pump - Disassemble