Rocker Arm and Shaft - Remove
Removal Procedure
Start By:
- Remove the valve mechanism cover. Refer to Disassembly and Assembly, "Valve Mechanism Cover - Remove and Install".
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
NOTICE |
---|
Put identification marks on each of the rocker arms and push rods in order to identify the proper location for installation. |
- Disconnect harness assemblies (3) .
Show/hide table
Illustration 1 | g01354540 |
- Remove nuts (1) and position harness assembly (2) out of the way.
- Loosen nuts (5) and loosen rocker arm adjustment screws (6) .
Show/hide table
Illustration 2 | g01354545 |
- Remove bolts (7) and remove the rocker arm shaft assembly (8) .
- Remove pushrods (4) .
Caterpillar Information System:
C7 and C9 On-Highway Engines Engine Monitoring Lamp Parameters
C9 On-highway Engine Valve Mechanism Cover - Remove and Install
3508C, 3512C and 3516C Marine Engines Water Pump - Remove
2007/02/01 New Improved Air Lines for Air Compressors Are Now Used {5502}
2009/10/05 New Improved Air Lines for Air Compressors Are Now Used on C15 and C18 Industrial Engines {5502}
3508C, 3512C and 3516C Marine Engines Exhaust Manifold - Remove and Install
C9 On-highway Engine Valve Mechanism Cover
Replacing the Combustion Head for the Aftertreatment Regeneration Device{1088, 1720, 1722} Replacing the Combustion Head for the Aftertreatment Regeneration Device{1088, 1720, 1722}
C4.4 (Mech) Industrial Engine Fuel System Primary Filter/Water Separator - Drain
C4.4 (Mech) Industrial Engine Fuel System Secondary Filter - Replace
C3.4 Engines for Caterpillar Built Machines Piston and Rings
3508C, 3512C and 3516C Marine Engines Exhaust Elbow - Remove and Install
CX35 On-Highway Transmission Transmission Planetary - Assemble
2007/02/01 Retirement of the Paper Version of Truck Engine News {1000}
G3516B and G3520B Generator Set Engines Engine Oil Pan - Remove
C9.3 Engines for Caterpillar Built Machines Rocker Arm and Shaft - Install
G3516B and G3520B Generator Set Engines Engine Oil Pan - Install
C4.4 and C6.6 Engines for Caterpillar Built Machines 5 Volt Sensor Supply Circuit - Test
G3516B and G3520B Generator Set Engines Electric Starting Motor - Remove and Install
3508C, 3512C and 3516C Marine Engines Water Pump - Install
3512B and 3516B High Displacement Locomotive Engines Maintenance Recommendations
C9 On-highway Engine Unit Injector - Install
G3520C and G3520E Engines Valve Mechanism
2007/04/09 A New Fan Pulley Group is Used {1359}