Valve Mechanism Cover
Show/hide table
 | |
| Illustration 1 | g01623146 |
Tighten the bolt 1 through bolt 10 in a numerical sequence that is shown in Illustration 1 to standard torque.
(1) Hand tighten the engine oil filter cap assembly until the O-ring seal seats fully on the valve mechanism cover.
Caterpillar Information System:
Replacing the Combustion Head for the Aftertreatment Regeneration Device{1088, 1720, 1722} Replacing the Combustion Head for the Aftertreatment Regeneration Device{1088, 1720, 1722}
C4.4 (Mech) Industrial Engine Fuel System Primary Filter/Water Separator - Drain
C4.4 (Mech) Industrial Engine Fuel System Secondary Filter - Replace
C3.4 Engines for Caterpillar Built Machines Piston and Rings
3508C, 3512C and 3516C Marine Engines Exhaust Elbow - Remove and Install
C11 and C13 On-Highway Engines Gear Group (Rear)
3508C, 3512C and 3516C Marine Engines Air Inlet Manifold - Remove and Install
C9 On-highway Engine Fuel Priming Pump - Remove and Install
2007/03/05 A New Fuel Indicator is Now Available {7456}
C3.4 Engines for Caterpillar Built Machines Connecting Rod
C3.4 Engines for Caterpillar Built Machines Crankshaft Seals
C3.4 Engines for Caterpillar Built Machines Cylinder Block
3508C, 3512C and 3516C Marine Engines Exhaust Manifold - Remove and Install
2009/10/05 New Improved Air Lines for Air Compressors Are Now Used on C15 and C18 Industrial Engines {5502}
2007/02/01 New Improved Air Lines for Air Compressors Are Now Used {5502}
3508C, 3512C and 3516C Marine Engines Water Pump - Remove
C9 On-highway Engine Valve Mechanism Cover - Remove and Install
C7 and C9 On-Highway Engines Engine Monitoring Lamp Parameters
C9 On-highway Engine Rocker Arm and Shaft - Remove
CX35 On-Highway Transmission Transmission Planetary - Assemble
2007/02/01 Retirement of the Paper Version of Truck Engine News {1000}
G3516B and G3520B Generator Set Engines Engine Oil Pan - Remove
C9.3 Engines for Caterpillar Built Machines Rocker Arm and Shaft - Install
G3516B and G3520B Generator Set Engines Engine Oil Pan - Install