Engine Does Not Crank
The engine does not crank because of causes that are not related to the programming of the transmission. The ignition switch is turned to the START position and the shifter display goes blank or changed from "NN" to "--". The battery is too low to maintain power to the transmission and/or the shifter.
If the transmissions Starter Interlock Output is used in order to control the engine starter, check the programming of the following:
- Engine Running Starter Inhibit Enable Status (Enabled or Disabled)
Check the following:
- While the transmission is in NEUTRAL and the engine speed is zero, the output should be ON (+battery voltage) when the Starter Input is ON (+battery voltage).
Caterpillar Information System:
C13 On-highway Engine Crankshaft
CX28, CX31 and CX35 On-Highway Transmissions Power Train Electronic Control System Transmission Does Not Automatically Shift Back Into Gear
C15 On-Highway Engine Engine Oil Pan
C11 and C13 Engines and 14M and 16M Motor Graders Shutdown (Ground Level) - Test
C15 On-Highway Engine Engine Oil Pan
G3304B and G3306B Engines Valve Lash Is Excessive
C11 and C13 Engines and 14M and 16M Motor Graders Sensor Supply - Test
G3520C and G3520E Generator Set Engines Indicator Lamp - Test
CX28, CX31 and CX35 On-Highway Transmissions Power Train Electronic Control System Transmission Does Not Automatically Shift Into Neutral
G3520C and G3520E Generator Set Engines Speed Control (Switch) - Test
G3520C and G3520E Generator Set Engines Generator Output Power Sensor - Set
G3520C and G3520E Generator Set Engines Timing - Calibrate
CX28, CX31 and CX35 On-Highway Transmissions Power Train Electronic Control System Replaced Relay or Solenoid Does Not Operate
C13 On-highway Engine Main Bearing Journal
CX28, CX31 and CX35 On-Highway Transmissions Power Train Electronic Control System Transmission Does Not Respond to Shift Selector
2006/09/11 Make Sure That the Plug and the Gasket are Installed in the Cylinder Head {1100, 1118}
G3520C and G3520E Generator Set Engines Sensor Signal (PWM) - Test
Reuse and Salvage for 3200 Engine Cylinder Blocks {1201} Reuse and Salvage for 3200 Engine Cylinder Blocks {1201}
Caterpillar Parts Pricing{1000, 7000, 756P} Caterpillar Parts Pricing{1000, 7000, 756P}
G3520C and G3520E Generator Set Engines Oil Pressure Is High
C15 On-Highway Engine Vibration Damper and Pulley
3500 Engines Air Shutoff - Remove and Install
G3520C and G3520E Generator Set Engines Sensor Signal (Analog, Passive) - Test
G3520C and G3520E Generator Set Engines Generator Output Power - Test