Transmission Does Not Automatically Shift Back Into Gear
The transmission does not automatically shift back in to a gear because of a possible failure in the Auto Neutral feature. This feature may include the following programming:
- Auto Neutral Function Enabled Status - Enabled
- Auto Neutral Switch Input Configuration - Switch to Ground, Switch to Battery (1 or 2) or Parking Brake
- Auto Neutral Gear Reengagement Brake Required Configuration (required or not required)
- Auto Neutral Reengagement Configuration (Disabled, enabled for forward, enabled for forward and reverse or enabled for reverse)
- Parking Brake Input Installation Status (Installed and neutralizer logic is enabled)
Normal Operation - When the Auto Neutral switch is closed with the service brake depressed (if required) and the Auto Reengagement Configuration is not programmed to Disabled, the transmission shifts back in to the previous gear. If the Auto Neutral switch is programmed to Parking Brake, the parking brake input must show activated before the shift is allowed.
Check the following:
- Verify that the Auto Neutral Switch status is Closed.
- If programmed, the parking brake input must show disabled.
- If the Service Brake is required for automatic reengagement of a gear, verify that the Service Brake switch status is depressed.
- Verify that the Auto Neutral Reengagement Configuration is not programmed to Disabled. If the configuration is programmed to Disabled, the operator is required to select NEUTRAL and the forward or reverse range before the transmission will shift out of NEUTRAL.
Caterpillar Information System:
C15 On-Highway Engine Engine Oil Pan
C11 and C13 Engines and 14M and 16M Motor Graders Shutdown (Ground Level) - Test
C15 On-Highway Engine Engine Oil Pan
G3304B and G3306B Engines Valve Lash Is Excessive
C11 and C13 Engines and 14M and 16M Motor Graders Sensor Supply - Test
G3520C and G3520E Generator Set Engines Indicator Lamp - Test
CX28, CX31 and CX35 On-Highway Transmissions Power Train Electronic Control System Transmission Does Not Automatically Shift Into Neutral
G3520C and G3520E Generator Set Engines Speed Control (Switch) - Test
G3520C and G3520E Generator Set Engines Generator Output Power Sensor - Set
G3520C and G3520E Generator Set Engines Timing - Calibrate
C13 On-highway Engine Exhaust Extension
G3600 Engines ECM Software - Install
C13 On-highway Engine Crankshaft
CX28, CX31 and CX35 On-Highway Transmissions Power Train Electronic Control System Engine Does Not Crank
CX28, CX31 and CX35 On-Highway Transmissions Power Train Electronic Control System Replaced Relay or Solenoid Does Not Operate
C13 On-highway Engine Main Bearing Journal
CX28, CX31 and CX35 On-Highway Transmissions Power Train Electronic Control System Transmission Does Not Respond to Shift Selector
2006/09/11 Make Sure That the Plug and the Gasket are Installed in the Cylinder Head {1100, 1118}
G3520C and G3520E Generator Set Engines Sensor Signal (PWM) - Test
Reuse and Salvage for 3200 Engine Cylinder Blocks {1201} Reuse and Salvage for 3200 Engine Cylinder Blocks {1201}
Caterpillar Parts Pricing{1000, 7000, 756P} Caterpillar Parts Pricing{1000, 7000, 756P}
G3520C and G3520E Generator Set Engines Oil Pressure Is High
C15 On-Highway Engine Vibration Damper and Pulley
3500 Engines Air Shutoff - Remove and Install