Crankshaft
Show/hide table
Illustration 1 | g01400785 |
(2) Crankshaft gear
(3) Connecting rod bearing journals |
(1) Use the thrust plates on the center main bearing only.
(B) Dimensions for crankshaft gear
- Average diameter of the crankshaft gear after assembly ...
136.20 ± 0.11 mm (5.362 ± 0.004 inch) - Maximum diameter of crankshaft gear after assembly ...
136.36 mm (5.368 inch) - Maximum diameter of crankshaft gear after assembly ...
(C) Maximum distance between the crankshaft gear and the crankshaft flange ...
(D) Installation depth of the dowel ...
Note: After the crankshaft is assembled into the block, the crankshaft end play should be a maximum of
Caterpillar Information System:
CX28, CX31 and CX35 On-Highway Transmissions Power Train Electronic Control System Transmission Does Not Automatically Shift Back Into Gear
C15 On-Highway Engine Engine Oil Pan
C11 and C13 Engines and 14M and 16M Motor Graders Shutdown (Ground Level) - Test
C15 On-Highway Engine Engine Oil Pan
G3304B and G3306B Engines Valve Lash Is Excessive
C11 and C13 Engines and 14M and 16M Motor Graders Sensor Supply - Test
G3520C and G3520E Generator Set Engines Indicator Lamp - Test
CX28, CX31 and CX35 On-Highway Transmissions Power Train Electronic Control System Transmission Does Not Automatically Shift Into Neutral
G3520C and G3520E Generator Set Engines Speed Control (Switch) - Test
G3520C and G3520E Generator Set Engines Generator Output Power Sensor - Set
G3520C and G3520E Generator Set Engines Timing - Calibrate
C13 On-highway Engine Exhaust Extension
CX28, CX31 and CX35 On-Highway Transmissions Power Train Electronic Control System Engine Does Not Crank
CX28, CX31 and CX35 On-Highway Transmissions Power Train Electronic Control System Replaced Relay or Solenoid Does Not Operate
C13 On-highway Engine Main Bearing Journal
CX28, CX31 and CX35 On-Highway Transmissions Power Train Electronic Control System Transmission Does Not Respond to Shift Selector
2006/09/11 Make Sure That the Plug and the Gasket are Installed in the Cylinder Head {1100, 1118}
G3520C and G3520E Generator Set Engines Sensor Signal (PWM) - Test
Reuse and Salvage for 3200 Engine Cylinder Blocks {1201} Reuse and Salvage for 3200 Engine Cylinder Blocks {1201}
Caterpillar Parts Pricing{1000, 7000, 756P} Caterpillar Parts Pricing{1000, 7000, 756P}
G3520C and G3520E Generator Set Engines Oil Pressure Is High
C15 On-Highway Engine Vibration Damper and Pulley
3500 Engines Air Shutoff - Remove and Install
G3520C and G3520E Generator Set Engines Sensor Signal (Analog, Passive) - Test