Exhaust Extension
Show/hide table
Illustration 1 | g01302872 |
Right side view of engine |
(1) Torque for two clamps ...
(2) Torque for the clamp ...
Caterpillar Information System:
G3600 Engines ECM Software - Install
C13 On-highway Engine Exhaust Extension
2006/11/27 An Updated Gasket for the Water Temperature Regulator Housing is Available {1355, 1380, 1393}
C11 and C13 Engines and 14M and 16M Motor Graders Sensor Signal (Analog, Active) - Test
G3520C and G3520E Generator Set Engines Control Module - Replace
G3520C and G3520E Generator Set Engines Electrical Connectors - Inspect
G3520C and G3520E Generator Set Engines ECM - Replace
G3600 Engines Prechamber - Clean/Inspect
G3520C and G3520E Generator Set Engines Starting - Test
G3520C and G3520E Generator Set Engines Speed/Timing - Test
C13 On-highway Engine Clean Gas Induction Valve
C1.1, C1.5 and C2.2 Engines for Caterpillar Built Machines Crankshaft Front Seal - Remove and Install
G3520C and G3520E Generator Set Engines Timing - Calibrate
G3520C and G3520E Generator Set Engines Generator Output Power Sensor - Set
G3520C and G3520E Generator Set Engines Speed Control (Switch) - Test
CX28, CX31 and CX35 On-Highway Transmissions Power Train Electronic Control System Transmission Does Not Automatically Shift Into Neutral
G3520C and G3520E Generator Set Engines Indicator Lamp - Test
C11 and C13 Engines and 14M and 16M Motor Graders Sensor Supply - Test
G3304B and G3306B Engines Valve Lash Is Excessive
C15 On-Highway Engine Engine Oil Pan
C11 and C13 Engines and 14M and 16M Motor Graders Shutdown (Ground Level) - Test
C15 On-Highway Engine Engine Oil Pan
CX28, CX31 and CX35 On-Highway Transmissions Power Train Electronic Control System Transmission Does Not Automatically Shift Back Into Gear
C13 On-highway Engine Crankshaft