Clean Gas Induction Valve
Show/hide table
Illustration 1 | g01401963 |
(1) Fill the double cavity approximately half full with 1P-0808 Multipurpose Grease.
Caterpillar Information System:
C1.1, C1.5 and C2.2 Engines for Caterpillar Built Machines Crankshaft Front Seal - Remove and Install
C0.5, C0.7, C1.1, C1.5, C1.6 and and C2.2 Industrial Engines Crankshaft Rear Seal - Remove and Install
C0.5, C0.7, C1.1, C1.5, C1.6 and and C2.2 Industrial Engines Fuel Injection Pump - Remove and Install
G3520C and G3520E Generator Set Engines Throttle Actuator - Test
C0.5, C0.7, C1.1, C1.5, C1.6 and and C2.2 Industrial Engines Fuel Injector - Remove and Install
C0.5, C0.7, C1.1, C1.5, C1.6 and and C2.2 Industrial Engines Fuel Filter Base - Remove and Install - C1.1, C1.5, C1.6 and C2.2 Engines
C0.5, C0.7, C1.1, C1.5, C1.6 and and C2.2 Industrial Engines Fuel Filter Base - Remove and Install - C0.5 and C0.7 Engines
C1.1, C1.5 and C2.2 Engines for Caterpillar Built Machines Fuel Transfer Pump - Remove and Install - Mechanical Fuel Transfer Pump
C1.1, C1.5 and C2.2 Engines for Caterpillar Built Machines Fuel Transfer Pump - Remove and Install - Electrical Fuel Transfer Pump
C11 and C13 Engines and 14M and 16M Motor Graders Injector Solenoid - Test
C1.1, C1.5 and C2.2 Engines for Caterpillar Built Machines Water Temperature Regulator Housing - Remove and Install
C0.5, C0.7, C1.1, C1.5, C1.6 and and C2.2 Industrial Engines Glow Plugs - Remove and Install
G3520C and G3520E Generator Set Engines Speed/Timing - Test
G3520C and G3520E Generator Set Engines Starting - Test
G3600 Engines Prechamber - Clean/Inspect
G3520C and G3520E Generator Set Engines ECM - Replace
G3520C and G3520E Generator Set Engines Electrical Connectors - Inspect
G3520C and G3520E Generator Set Engines Control Module - Replace
C11 and C13 Engines and 14M and 16M Motor Graders Sensor Signal (Analog, Active) - Test
2006/11/27 An Updated Gasket for the Water Temperature Regulator Housing is Available {1355, 1380, 1393}
C13 On-highway Engine Exhaust Extension
G3600 Engines ECM Software - Install
C13 On-highway Engine Exhaust Extension
G3520C and G3520E Generator Set Engines Timing - Calibrate