Make Sure That the Plug and the Gasket are Installed in the Cylinder Head {1100, 1118}
- Engine:
- 3606 (S/N: 8RB1-UP)
- 3608 (S/N: 6MC1-UP; 5PG1-UP; 1ZD1-UP; 8LL1-UP; 7WR1-UP)
- 3612 (S/N: NZA1-UP; 9FR1-UP; 2NZ1-UP; 9RC1-UP)
- 3616 (S/N: 1PD1-UP; RMN1-UP; 1FN1-UP)
Show/hide table
 | |
| Illustration 1 | g01304168 |
(1) 4P-7639 Cylinder Pressure Plug (2) 7E-8276 Gasket | |
Before you install the cylinder head, make sure that the plug and the gasket are installed. If the head is installed on an engine without the plug, combustion gases will blow out the cylinder head pressure relief port.
Verify that the 4P-7639 Cylinder Pressure Plug and the 7E-8276 Gasket is installed in the 0R-7467 Cylinder Head Gp with the following date codes:
- 16506
- 17206
- 17306
- 17406
Caterpillar Information System:
CX28, CX31 and CX35 On-Highway Transmissions Power Train Electronic Control System Transmission Does Not Respond to Shift Selector
C13 On-highway Engine Main Bearing Journal
CX28, CX31 and CX35 On-Highway Transmissions Power Train Electronic Control System Replaced Relay or Solenoid Does Not Operate
CX28, CX31 and CX35 On-Highway Transmissions Power Train Electronic Control System Engine Does Not Crank
C13 On-highway Engine Crankshaft
CX28, CX31 and CX35 On-Highway Transmissions Power Train Electronic Control System Transmission Does Not Automatically Shift Back Into Gear
C15 On-Highway Engine Engine Oil Pan
C11 and C13 Engines and 14M and 16M Motor Graders Shutdown (Ground Level) - Test
C15 On-Highway Engine Engine Oil Pan
G3304B and G3306B Engines Valve Lash Is Excessive
C11 and C13 Engines and 14M and 16M Motor Graders Sensor Supply - Test
G3520C and G3520E Generator Set Engines Indicator Lamp - Test
G3520C and G3520E Generator Set Engines Sensor Signal (PWM) - Test
Reuse and Salvage for 3200 Engine Cylinder Blocks {1201} Reuse and Salvage for 3200 Engine Cylinder Blocks {1201}
Caterpillar Parts Pricing{1000, 7000, 756P} Caterpillar Parts Pricing{1000, 7000, 756P}
G3520C and G3520E Generator Set Engines Oil Pressure Is High
C15 On-Highway Engine Vibration Damper and Pulley
3500 Engines Air Shutoff - Remove and Install
G3520C and G3520E Generator Set Engines Sensor Signal (Analog, Passive) - Test
G3520C and G3520E Generator Set Engines Generator Output Power - Test
G3520C and G3520E Generator Set Engines Sensor Signal (Analog, Active) - Test
C11 and C13 Engines and 14M and 16M Motor Graders Speed Control (Switch) - Test
3512B Marine Auxiliary Engine Speed Sensor - Clean/Inspect
3512B Marine Auxiliary Engine Starting Motor - Inspect