Transmission Does Not Respond to Shift Selector
The shifter may not work properly if the transmission is not connected to the vehicle battery, the ignition switch is not connected or the J1939 Data Link is wiring is disconnected. The shift pad will display "--" instead of "NN" when the key start switch is turned to the ON position.
Check the following:
- Check for battery power to the Transmission ECU.
- Check for ignition power to the Transmission ECU.
- Check the J1939 Data Link wires and connectors.
- Verify that the correct serial number for the Transmission ECU has been programmed.
See the Testing and Adjusting, "Electrical Connector - Inspect" section of this manual for more information.
If the shifter only displays the right side digit, the serial number for the torque converter may not be programmed. Verify that the correct serial number for the torque converter has been programmed.
Caterpillar Information System:
C13 On-highway Engine Main Bearing Journal
CX28, CX31 and CX35 On-Highway Transmissions Power Train Electronic Control System Replaced Relay or Solenoid Does Not Operate
CX28, CX31 and CX35 On-Highway Transmissions Power Train Electronic Control System Engine Does Not Crank
C13 On-highway Engine Crankshaft
CX28, CX31 and CX35 On-Highway Transmissions Power Train Electronic Control System Transmission Does Not Automatically Shift Back Into Gear
C15 On-Highway Engine Engine Oil Pan
C11 and C13 Engines and 14M and 16M Motor Graders Shutdown (Ground Level) - Test
C15 On-Highway Engine Engine Oil Pan
G3304B and G3306B Engines Valve Lash Is Excessive
C11 and C13 Engines and 14M and 16M Motor Graders Sensor Supply - Test
G3520C and G3520E Generator Set Engines Indicator Lamp - Test
CX28, CX31 and CX35 On-Highway Transmissions Power Train Electronic Control System Transmission Does Not Automatically Shift Into Neutral
2006/09/11 Make Sure That the Plug and the Gasket are Installed in the Cylinder Head {1100, 1118}
G3520C and G3520E Generator Set Engines Sensor Signal (PWM) - Test
Reuse and Salvage for 3200 Engine Cylinder Blocks {1201} Reuse and Salvage for 3200 Engine Cylinder Blocks {1201}
Caterpillar Parts Pricing{1000, 7000, 756P} Caterpillar Parts Pricing{1000, 7000, 756P}
G3520C and G3520E Generator Set Engines Oil Pressure Is High
C15 On-Highway Engine Vibration Damper and Pulley
3500 Engines Air Shutoff - Remove and Install
G3520C and G3520E Generator Set Engines Sensor Signal (Analog, Passive) - Test
G3520C and G3520E Generator Set Engines Generator Output Power - Test
G3520C and G3520E Generator Set Engines Sensor Signal (Analog, Active) - Test
C11 and C13 Engines and 14M and 16M Motor Graders Speed Control (Switch) - Test
3512B Marine Auxiliary Engine Speed Sensor - Clean/Inspect