Flywheel - Install
Show/hide table
Required Tools | |||
Tool | Part Number | Part Description | Qty |
A | - | Guide Bolt M12 X 1.75 by 120 mm |
1 |
B | 9S-3263 | Thread Lock Compound | 1 |
- Raise the temperature of the flywheel ring gear. Position the flywheel ring gear on the flywheel with the part number toward the crankshaft. Use a soft hammer in order to seat the flywheel ring gear against the shoulder of the flywheel. Allow the flywheel ring gear to cool.
Show/hide table
Illustration 1 g01265489 Show/hide tableIllustration 2 g01265514 - Position flywheel (5) on Tooling (A). Install flywheel (5) on the dowel in the crankshaft. Install hub (3), flex plate (4), and spacer plate (2).
- Apply Tooling (B) to the threads of bolts (1). Install bolts (1). Remove Tooling (A) and install remaining bolt (1). Tighten bolts (1) evenly to a torque of
120 ± 20 N·m (90 ± 15 lb ft) . - Check the flywheel runout. Refer to Testing and Adjusting, "Flywheel - Inspect".
Note: Do not use a torch to heat the flywheel ring gear.
End By:
- Install the electric starting motor. Refer to Disassembly and Assembly, "Electric Starting Motor - Remove and Install".
Caterpillar Information System:
770 and 772 Off-Highway Trucks Automatic Lubrication System Visual Inspection
3500B Industrial Engines with the ADEM 3 Electronic Control Module Cat Data Link
C7 On-Highway Engine Flywheel - Remove
C13 Engine for Caterpillar Built Machines Valve Actuator (Variable) - Remove and Install
C15 and C18 Industrial Engines Flywheel Housing - Remove and Install
3500B Industrial Engines with the ADEM 3 Electronic Control Module CAN Data Link
C7 On-Highway Engine Inlet Manifold Temperature Sensor - Remove and Install
C13 Engine Vibration Damper and Pulley - Remove and Install
C7 On-Highway Engine Inlet Manifold Pressure Sensor - Remove and Install
3512C Engine Programmable System Parameters
C7 On-Highway Engine Fuel Pressure Sensor - Remove and Install - Rail
2006/05/15 New ECM Software is Available {7620}
TA19-M2WD and TA19-M4WD Agricultural Transmissions Modulating Valve (Transmission Clutch) - Remove and Install
3044C Industrial Engine Plate Locations and Film Locations
3500B Industrial Engines with the ADEM 3 Electronic Control Module Electrical Power Supply
TA19-M2WD and TA19-M4WD Agricultural Transmissions Relief Valve (Transmission Main) - Remove
TA19-M2WD and TA19-M4WD Agricultural Transmissions Relief Valve (Transmission Main) - Install
C7 On-Highway Engine Fuel Transfer Pump - Remove
G3304 and G3306 Engines Coolant Level Sensor
3412E and C30 Marine Engines Cooling System Coolant (DEAC) - Change
C13 Engine Accessory Drive - Disassemble
3412E and C30 Marine Engines Cooling System Coolant (ELC) - Change
C7 On-Highway Engine Fuel Transfer Pump - Install
C13 Engine Accessory Drive - Assemble