Fuel Transfer Pump - Remove
Start By:
- Remove the fuel manifold. Refer to Disassembly and Assembly, "Fuel Control Mainfold (ARD) - Remove".
Show/hide table
| NOTICE |
|---|
|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products. Dispose of all fluids according to local regulations and mandates. |
Show/hide table
| NOTICE |
|---|
|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Remove bolts (1). Remove nut (2).
Show/hide table
Illustration 2 g01265656 - Remove nut (3). Remove bracket (4).
Show/hide table
Illustration 3 g01265657 - Remove stud (5) and bolt (6).
Show/hide table
Illustration 4 g01265658 - Remove stud (7) and bolt (8). Remove fuel transfer pump (9).
Show/hide table
| |
| Illustration 1 | g01265654 |
Caterpillar Information System:
TA19-M2WD and TA19-M4WD Agricultural Transmissions Relief Valve (Transmission Main) - Install
TA19-M2WD and TA19-M4WD Agricultural Transmissions Relief Valve (Transmission Main) - Remove
3500B Industrial Engines with the ADEM 3 Electronic Control Module Electrical Power Supply
3044C Industrial Engine Plate Locations and Film Locations
TA19-M2WD and TA19-M4WD Agricultural Transmissions Modulating Valve (Transmission Clutch) - Remove and Install
C7 On-Highway Engine Flywheel - Install
770 and 772 Off-Highway Trucks Automatic Lubrication System Visual Inspection
3500B Industrial Engines with the ADEM 3 Electronic Control Module Cat Data Link
C7 On-Highway Engine Flywheel - Remove
C13 Engine for Caterpillar Built Machines Valve Actuator (Variable) - Remove and Install
C15 and C18 Industrial Engines Flywheel Housing - Remove and Install
3500B Industrial Engines with the ADEM 3 Electronic Control Module CAN Data Link
G3304 and G3306 Engines Coolant Level Sensor
3412E and C30 Marine Engines Cooling System Coolant (DEAC) - Change
C13 Engine Accessory Drive - Disassemble
3412E and C30 Marine Engines Cooling System Coolant (ELC) - Change
C7 On-Highway Engine Fuel Transfer Pump - Install
C13 Engine Accessory Drive - Assemble
C27 and C32 Engines for Caterpillar Built Machines Water Temperature Regulator Housing - Remove and Install
TA19-M2WD and TA19-M4WD Agricultural Transmissions Pump Drive - Remove
C9 On-highway Engine Fuel Control Manifold (ARD) - Disassemble
C9 On-highway Engine Fuel Control Manifold (ARD) - Assemble
3500B Industrial Engines with the ADEM 3 Electronic Control Module Emergency Stop Switch
770, 772, 773E, 773F, 777E and 777F Off-Highway Trucks and 775F Quarry Truck VIMS Truck Payload System Electronic Control Module (ECM) - Configure