Visual Inspection
发现问题时，目视检查自动润滑系统。 采用以下方式目视检查整个自动润滑系统。
- 检查喷油器排、所有润滑管路和所有接头有无润滑油泄漏。
- 检查电气系统有无磨损或擦伤的线路。 另外，检查电气系统有无损坏的接头或不良保险丝。
Caterpillar Information System:
3500B Industrial Engines with the ADEM 3 Electronic Control Module Cat Data Link
C7 On-Highway Engine Flywheel - Remove
C13 Engine for Caterpillar Built Machines Valve Actuator (Variable) - Remove and Install
C15 and C18 Industrial Engines Flywheel Housing - Remove and Install
3500B Industrial Engines with the ADEM 3 Electronic Control Module CAN Data Link
C7 On-Highway Engine Inlet Manifold Temperature Sensor - Remove and Install
C13 Engine Vibration Damper and Pulley - Remove and Install
C7 On-Highway Engine Inlet Manifold Pressure Sensor - Remove and Install
3512C Engine Programmable System Parameters
C7 On-Highway Engine Fuel Pressure Sensor - Remove and Install - Rail
2006/05/15 New ECM Software is Available {7620}
C7 Urban Transit Bus Engines Cooling System Coolant Sample (Level 2) - Obtain
C7 On-Highway Engine Flywheel - Install
TA19-M2WD and TA19-M4WD Agricultural Transmissions Modulating Valve (Transmission Clutch) - Remove and Install
3044C Industrial Engine Plate Locations and Film Locations
3500B Industrial Engines with the ADEM 3 Electronic Control Module Electrical Power Supply
TA19-M2WD and TA19-M4WD Agricultural Transmissions Relief Valve (Transmission Main) - Remove
TA19-M2WD and TA19-M4WD Agricultural Transmissions Relief Valve (Transmission Main) - Install
C7 On-Highway Engine Fuel Transfer Pump - Remove
G3304 and G3306 Engines Coolant Level Sensor
3412E and C30 Marine Engines Cooling System Coolant (DEAC) - Change
C13 Engine Accessory Drive - Disassemble
3412E and C30 Marine Engines Cooling System Coolant (ELC) - Change
C7 On-Highway Engine Fuel Transfer Pump - Install