Removal Procedure
Required Tools     | |||
Tool     | Part Number     | Part Description     | Qty     |
A     | 5P-0332     | Crowfoot Wrench     | 1     |
NOTICE |
---|
Contact with high pressure fuel may cause personal injury or death. Wait 60 seconds after the engine has stopped to allow fuel pressure to purge before any service or repair is performed on the engine fuel lines. |
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Dispose of all fluids according to local regulations and mandates. |
Contact with high pressure fuel may cause fluid penetration and burn hazards. High pressure fuel spray may cause a fire hazard. Failure to follow these inspection, maintenance and service instructions may cause personal injury or death. |
- Disconnect harness assembly (1) .
Illustration 1 | g01265340 |
- Use Tooling (A) in order to remove fuel pressure sensor (2) . Discard fuel pressure sensor (2) .
NOTICE |
---|
Fuel pressure sensor (2) must only be used once. Discard fuel pressure sensor (2) after use. |
Installation Procedure
Required Tools     | |||
Tool     | Part Number     | Part Description     | Qty     |
A     | 5P-0332     | Crowfoot Wrench     | 1     |
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Use Tooling (A) in order to install new fuel pressure sensor (2) . Tighten fuel pressure sensor (2) to a torque of 35 ± 3 N·m (26 ± 2 lb ft).
Illustration 2 | g01265340 |
- Connect harness assembly (1) .