Inlet Manifold Pressure Sensor - Remove and Install
- Disconnect harness assembly (1).
- Remove pressure sensor (2).
Show/hide table
| |
| Illustration 1 | g01265388 |
- Install pressure sensor (2). Tighten pressure sensor (2) to a torque of
10 ± 2 N·m (89 ± 18 lb in) . - Connect harness assembly (1).
Show/hide table
|
| |
| Illustration 2 | g01265388 |
Caterpillar Information System:
3512C Engine Programmable System Parameters
C7 On-Highway Engine Fuel Pressure Sensor - Remove and Install - Rail
2006/05/15 New ECM Software is Available {7620}
C7 Urban Transit Bus Engines Cooling System Coolant Sample (Level 2) - Obtain
C13 Engine Water Temperature Regulator - Remove and Install
C4.4 Industrial Engine Fuel Injection
C13 and C15 On-Highway Engines Customer Assistance
UPS 1000S/ UPS 1200S Uninterruptible Power Supplys Service Connections
UPS 1000S/ UPS 1200S Uninterruptible Power Supplys Discharge Modes
2006/04/24 A New Tube Assembly is Released {1380}
2006/06/05 Improved Balance Disc is Now Available {4457}
TA19-M2WD and TA19-M4WD Agricultural Transmissions Speed Sensor (Transmission) - Install
C13 Engine Vibration Damper and Pulley - Remove and Install
C7 On-Highway Engine Inlet Manifold Temperature Sensor - Remove and Install
3500B Industrial Engines with the ADEM 3 Electronic Control Module CAN Data Link
C15 and C18 Industrial Engines Flywheel Housing - Remove and Install
C13 Engine for Caterpillar Built Machines Valve Actuator (Variable) - Remove and Install
C7 On-Highway Engine Flywheel - Remove
3500B Industrial Engines with the ADEM 3 Electronic Control Module Cat Data Link
770 and 772 Off-Highway Trucks Automatic Lubrication System Visual Inspection
C7 On-Highway Engine Flywheel - Install
TA19-M2WD and TA19-M4WD Agricultural Transmissions Modulating Valve (Transmission Clutch) - Remove and Install
3044C Industrial Engine Plate Locations and Film Locations
3500B Industrial Engines with the ADEM 3 Electronic Control Module Electrical Power Supply