Accessory Drive - Disassemble
Disassembly Procedure
Show/hide table
Required Tools     | |||
---|---|---|---|
Tool     | Part Number     | Part Description     | Qty     |
A     | 8B-7551     | Bearing Puller Gp     | 1     |
Note: Cleanliness is an important factor. Before you begin the disassembly procedure, the exterior of the components should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism. Precision components can be damaged by contaminants or by dirt. Perform disassembly procedures on a clean work surface. Keep components covered and protected at all times.
- Remove bolts (1), housing (2), and accessory drive (3) .
Show/hide table
Illustration 1 | g01265687 |
- Use Tooling (A) and a suitable press in order to remove bearing (4) from gear (5) .
Show/hide table
Illustration 2 | g01265688 |
- Use Tooling (A) and a suitable press in order to remove bearing (6) from gear (5) .
Show/hide table
Illustration 3 | g01265689 |
Caterpillar Information System:
3412E and C30 Marine Engines Cooling System Coolant (DEAC) - Change
G3304 and G3306 Engines Coolant Level Sensor
C7 On-Highway Engine Fuel Transfer Pump - Remove
TA19-M2WD and TA19-M4WD Agricultural Transmissions Relief Valve (Transmission Main) - Install
TA19-M2WD and TA19-M4WD Agricultural Transmissions Relief Valve (Transmission Main) - Remove
3500B Industrial Engines with the ADEM 3 Electronic Control Module Electrical Power Supply
3044C Industrial Engine Plate Locations and Film Locations
TA19-M2WD and TA19-M4WD Agricultural Transmissions Modulating Valve (Transmission Clutch) - Remove and Install
C7 On-Highway Engine Flywheel - Install
770 and 772 Off-Highway Trucks Automatic Lubrication System Visual Inspection
3500B Industrial Engines with the ADEM 3 Electronic Control Module Cat Data Link
C7 On-Highway Engine Flywheel - Remove
3412E and C30 Marine Engines Cooling System Coolant (ELC) - Change
C7 On-Highway Engine Fuel Transfer Pump - Install
C13 Engine Accessory Drive - Assemble
C27 and C32 Engines for Caterpillar Built Machines Water Temperature Regulator Housing - Remove and Install
TA19-M2WD and TA19-M4WD Agricultural Transmissions Pump Drive - Remove
C9 On-highway Engine Fuel Control Manifold (ARD) - Disassemble
C9 On-highway Engine Fuel Control Manifold (ARD) - Assemble
3500B Industrial Engines with the ADEM 3 Electronic Control Module Emergency Stop Switch
770, 772, 773E, 773F, 777E and 777F Off-Highway Trucks and 775F Quarry Truck VIMS Truck Payload System Electronic Control Module (ECM) - Configure
C7 On-Highway Engine Clean Gas Induction Valve - Disassemble
C11, C13, and C15 On-highway Engines Fuel System Primary Filter - Replace
3500B Industrial Engines with the ADEM 3 Electronic Control Module Ether Injection System