Clean Gas Induction Valve - Disassemble
Start By:
- Remove the clean gas induction valve. Refer to Disassembly and Assembly, "Clean Gas Induction Valve - Remove".
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Note: This component is being disassembled and displayed for CLEANING PURPOSES ONLY. Many internal parts are not available for this component. Care must be taken during disassembly and assembly in order to prevent damage to unavailable parts.
- Remove O-ring seal (1).
Show/hide table
Illustration 2 g01299977 - Remove O-ring seal (2).
Show/hide table
Illustration 3 g01299978 - Remove bolts (3). Remove cover (4).
Show/hide table
Illustration 4 g01265786 - Remove nut (5), coil assembly (6), and valve (7). Remove O-ring seals (8) from cover (4).
Show/hide table
Illustration 5 g01265787 - Remove O-ring seal (9). Check wiper (12) for wear or damage. Remove bolts (10). Remove housing (11).
Show/hide table
Illustration 6 g01265789 - Check O-ring seal (13) for wear or for damage.
Show/hide table
Illustration 1 | g01299976 |
Caterpillar Information System:
770, 772, 773E, 773F, 777E and 777F Off-Highway Trucks and 775F Quarry Truck VIMS Truck Payload System Electronic Control Module (ECM) - Configure
3500B Industrial Engines with the ADEM 3 Electronic Control Module Emergency Stop Switch
C9 On-highway Engine Fuel Control Manifold (ARD) - Assemble
C9 On-highway Engine Fuel Control Manifold (ARD) - Disassemble
TA19-M2WD and TA19-M4WD Agricultural Transmissions Pump Drive - Remove
C27 and C32 Engines for Caterpillar Built Machines Water Temperature Regulator Housing - Remove and Install
C13 Engine Accessory Drive - Assemble
C7 On-Highway Engine Fuel Transfer Pump - Install
3412E and C30 Marine Engines Cooling System Coolant (ELC) - Change
C13 Engine Accessory Drive - Disassemble
3412E and C30 Marine Engines Cooling System Coolant (DEAC) - Change
G3304 and G3306 Engines Coolant Level Sensor
C11, C13, and C15 On-highway Engines Fuel System Primary Filter - Replace
3500B Industrial Engines with the ADEM 3 Electronic Control Module Ether Injection System
C7 On-Highway Engine Flame Detection Temperature Sensor - Remove and Install
3500B Industrial Engines with the ADEM 3 Electronic Control Module Engine Speed/Timing Sensor
C7 On-Highway Engine Turbocharger Outlet Temperature Sensor - Remove and Install
C27 and C32 Engines for Caterpillar Built Machines Fuel Filter Base - Remove - C27
C7 On-Highway Engine Atmospheric Pressure Sensor - Remove and Install
C27 and C32 Engines for Caterpillar Built Machines Fuel Filter Base - Install - C27
C7 On-Highway Engine Inlet Air Temperature Sensor - Remove and Install
C27 and C32 Engines for Caterpillar Built Machines Valve Mechanism Cover - Remove and Install - C27
C27 and C32 Engines for Caterpillar Built Machines Flywheel Housing - Remove and Install - C27
C27 and C32 Engines for Caterpillar Built Machines Cylinder Head - Remove - C27