Fuel Filter Base - Install - C27
Prosedur Pemasangan
Show/hide table
| PERHATIAN |
|---|
Jaga agar semua komponen telah bersih dari bahan penyebab kontaminasi. Bahan penyebab kontaminasi dapat menyebabkan keausan yang sangat cepat dan umur pemakaian komponen yang lebih singkat. |
- Letakkan dudukan filter bahan bakar (5) pada engine.
Show/hide table
 | |
| Ilustrasi 1 | g01265878 |
- Pasang baut (3), ring, dan mur (4) .
- Pasang filter bahan bakar (6) pada dudukan filter bahan bakar (5) .
- Sambungkan susunan selang (2) dan (7) .
- Sambungkan susunan rangkaian kabel (1) .
- Putar suplai bahan bakar ke posisi "ON".
Caterpillar Information System:
C7 On-Highway Engine Atmospheric Pressure Sensor - Remove and Install
C27 and C32 Engines for Caterpillar Built Machines Fuel Filter Base - Remove - C27
C7 On-Highway Engine Turbocharger Outlet Temperature Sensor - Remove and Install
3500B Industrial Engines with the ADEM 3 Electronic Control Module Engine Speed/Timing Sensor
C7 On-Highway Engine Flame Detection Temperature Sensor - Remove and Install
3500B Industrial Engines with the ADEM 3 Electronic Control Module Ether Injection System
C11, C13, and C15 On-highway Engines Fuel System Primary Filter - Replace
C7 On-Highway Engine Clean Gas Induction Valve - Disassemble
770, 772, 773E, 773F, 777E and 777F Off-Highway Trucks and 775F Quarry Truck VIMS Truck Payload System Electronic Control Module (ECM) - Configure
3500B Industrial Engines with the ADEM 3 Electronic Control Module Emergency Stop Switch
C9 On-highway Engine Fuel Control Manifold (ARD) - Assemble
C9 On-highway Engine Fuel Control Manifold (ARD) - Disassemble
C7 On-Highway Engine Inlet Air Temperature Sensor - Remove and Install
C27 and C32 Engines for Caterpillar Built Machines Valve Mechanism Cover - Remove and Install - C27
C27 and C32 Engines for Caterpillar Built Machines Flywheel Housing - Remove and Install - C27
C27 and C32 Engines for Caterpillar Built Machines Cylinder Head - Remove - C27
C9 On-highway Engine Gear Group (Rear)
C27 and C32 Engines for Caterpillar Built Machines Cylinder Head - Install - C27
C175-16 and C175-20 Generator Set Engines Valve Mechanism
BA-921 Bendix Air Compressor Air Compressor is Noisy
C7 On-Highway Engine Solenoid Valve (ARD Main Fuel) - Remove and Install
C13 Engine Boost Pressure Sensor - Remove and Install
C27 and C32 Engines for Caterpillar Built Machines Camshaft - Install - C27
2006/08/07 A New Oil Pump for the Hydrax System is Used {1716, 5073}