Turbocharger Outlet Temperature Sensor - Remove and Install
- Remove cable strap (1).
- Disconnect harness assembly (2) from temperature sensor (3).
Show/hide table
Illustration 2 g01265877 - Remove temperature probe (4).
- Remove the temperature sensor.
Show/hide table
Illustration 1 | g01265876 |
- Position the temperature sensor.
Show/hide table
Illustration 3 g01265877 - Install temperature probe (4).
Show/hide table
Illustration 4 g01265876 - Connect harness assembly (2 ) onto temperature sensor (3).
- Install a new cable strap (1).
Caterpillar Information System:
3500B Industrial Engines with the ADEM 3 Electronic Control Module Engine Speed/Timing Sensor
C7 On-Highway Engine Flame Detection Temperature Sensor - Remove and Install
3500B Industrial Engines with the ADEM 3 Electronic Control Module Ether Injection System
C11, C13, and C15 On-highway Engines Fuel System Primary Filter - Replace
C7 On-Highway Engine Clean Gas Induction Valve - Disassemble
770, 772, 773E, 773F, 777E and 777F Off-Highway Trucks and 775F Quarry Truck VIMS Truck Payload System Electronic Control Module (ECM) - Configure
3500B Industrial Engines with the ADEM 3 Electronic Control Module Emergency Stop Switch
C9 On-highway Engine Fuel Control Manifold (ARD) - Assemble
C9 On-highway Engine Fuel Control Manifold (ARD) - Disassemble
TA19-M2WD and TA19-M4WD Agricultural Transmissions Pump Drive - Remove
C27 and C32 Engines for Caterpillar Built Machines Water Temperature Regulator Housing - Remove and Install
C13 Engine Accessory Drive - Assemble
C27 and C32 Engines for Caterpillar Built Machines Fuel Filter Base - Remove - C27
C7 On-Highway Engine Atmospheric Pressure Sensor - Remove and Install
C27 and C32 Engines for Caterpillar Built Machines Fuel Filter Base - Install - C27
C7 On-Highway Engine Inlet Air Temperature Sensor - Remove and Install
C27 and C32 Engines for Caterpillar Built Machines Valve Mechanism Cover - Remove and Install - C27
C27 and C32 Engines for Caterpillar Built Machines Flywheel Housing - Remove and Install - C27
C27 and C32 Engines for Caterpillar Built Machines Cylinder Head - Remove - C27
C9 On-highway Engine Gear Group (Rear)
C27 and C32 Engines for Caterpillar Built Machines Cylinder Head - Install - C27
C175-16 and C175-20 Generator Set Engines Valve Mechanism
BA-921 Bendix Air Compressor Air Compressor is Noisy
C7 On-Highway Engine Solenoid Valve (ARD Main Fuel) - Remove and Install