Inlet Air Temperature Sensor - Remove and Install
- Disconnect harness assembly (1).
- Remove inlet air temperature sensor (2).
Show/hide table
Illustration 1 | g01265906 |
- Install inlet air temperature sensor (2). Tighten inlet air temperature sensor (2) to a torque of
20 ± 5 N·m (15 ± 4 lb ft) . - Connect harness assembly (1).
Show/hide table
Illustration 2 | g01265906 |
Caterpillar Information System:
C27 and C32 Engines for Caterpillar Built Machines Fuel Filter Base - Install - C27
C7 On-Highway Engine Atmospheric Pressure Sensor - Remove and Install
C27 and C32 Engines for Caterpillar Built Machines Fuel Filter Base - Remove - C27
C7 On-Highway Engine Turbocharger Outlet Temperature Sensor - Remove and Install
3500B Industrial Engines with the ADEM 3 Electronic Control Module Engine Speed/Timing Sensor
C7 On-Highway Engine Flame Detection Temperature Sensor - Remove and Install
3500B Industrial Engines with the ADEM 3 Electronic Control Module Ether Injection System
C11, C13, and C15 On-highway Engines Fuel System Primary Filter - Replace
C7 On-Highway Engine Clean Gas Induction Valve - Disassemble
770, 772, 773E, 773F, 777E and 777F Off-Highway Trucks and 775F Quarry Truck VIMS Truck Payload System Electronic Control Module (ECM) - Configure
3500B Industrial Engines with the ADEM 3 Electronic Control Module Emergency Stop Switch
C9 On-highway Engine Fuel Control Manifold (ARD) - Assemble
C27 and C32 Engines for Caterpillar Built Machines Valve Mechanism Cover - Remove and Install - C27
C27 and C32 Engines for Caterpillar Built Machines Flywheel Housing - Remove and Install - C27
C27 and C32 Engines for Caterpillar Built Machines Cylinder Head - Remove - C27
C9 On-highway Engine Gear Group (Rear)
C27 and C32 Engines for Caterpillar Built Machines Cylinder Head - Install - C27
C175-16 and C175-20 Generator Set Engines Valve Mechanism
BA-921 Bendix Air Compressor Air Compressor is Noisy
C7 On-Highway Engine Solenoid Valve (ARD Main Fuel) - Remove and Install
C13 Engine Boost Pressure Sensor - Remove and Install
C27 and C32 Engines for Caterpillar Built Machines Camshaft - Install - C27
2006/08/07 A New Oil Pump for the Hydrax System is Used {1716, 5073}
C7 On-Highway Engine Air Inlet Cover - Remove and Install